HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 81
set dom1 fan spd
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Troubleshooting Identifying LCD-Indicated Conditions Table 3-1. Chassis Codes for J5000 and J7000 Workstations Ostat INI INI INI INI INI TST WRN INI INI WRN FLT WRN Code FRU CC0n SYS BD CC1n SYS BD CC2n SYS BD CC3n SYS BD CC4n SYS BD D000 SYS BD D004 SYS BD D005 SYS BD D006 SYS BD D007 SYS BD D01n D02n SYS/IO SYS/IO Message Description CPUn OS rendezvs Slave CPU n entering the final rendezvous, waiting for the operating system to awaken it. CPUn early rend Slave CPU n entering the early rendezvous, waiting for the monarch CPU to initialize scratch RAM and other system state. CPUn rendezvous Slave CPU n entering rendezvous. Slave CPUs enter this rendezvous numerous times during boot. CPUn cache rend Slave CPU n entering cached rendezvous, waiting for the monarch CPU to configure the system bus. CPUn mem rendez Slave CPU n entering memory rendezvous, waiting for the monarch CPU to select a boot device. micro controller Firmware is initializing communications with the system controller. micro not resp Firmware detected a communications error with the system controller. set dom1 fan spd Firmware is initializing communications with the system controller. set dom2 fan spd Firmware is initializing communications with the system controller. bad microctl cmd Firmware detected a communications error with the system controller. fan n: failure! Firmware detected system fan n stopped. fan n: too slow! Firmware detected system fan n is running too slowly. Chapter 3 77