HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 126
Removing the PCI Retainer Clip, I/O Slot Screw, Replacing an I/O Card
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Field Replaceable Units (FRUs) FRU Removal and Replacement Figure 4-35. Removing the PCI Retainer Clip 4. Remove the screw that secures the I/O card to the I/O slot. An example I/O slot screw for an installed I/O card is shown in Figure 4-36. Save the screw for future use (for example, to install a new I/O card or to replace the I/O slot with a filler plate). Figure 4-36. I/O Slot Screw Screw for securing I/O card to I/O slot 5. Grasp the I/O card by its edge and pull straight out. Place the I/O card in an antistatic bag for storage. Replacing an I/O Card To replace an I/O card, do the following: 1. Remove the top panel and the right side panel of the workstation. 2. Locate the I/O board and its I/O slots on the right side of the workstation, as shown in Figure 4-34 on the previous page. Note that the I/O board extends up behind the power supply, and that the eight I/O slots are located below the power supply. 122 Chapter 4