HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 40
Overview, Workstation Configurations, Field Replaceable Unit FRU Configurations
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Configuration Chapter Overview Chapter Overview This chapter contains the following main sections: • Workstation Configurations • Field Replaceable Unit (FRU) Configurations - Internal Storage Devices - Memory - I/O Cards - Monitor-Type Selection Workstation Configurations Refer to the HP Workstations Website for a complete list of supported accessories, peripherals, and operating system versions for the J5000 and J7000 workstations. The URL for the Website is: http://hp.unixworkstations.com Field Replaceable Unit (FRU) Configurations This section provides information for setting up or changing the configuration of the Field Replaceable Units (FRUs) for the J5000 and J7000 workstations. Internal Storage Devices Hard Disk Drive Configuration The SCSI IDs for hard disk drives are hard-wired into the SCA Ultra2 Wide LVD SCSI interfaces in the backplane of the four disk bays within the J5000 and J7000 workstations. Hence, SCSI IDs do not need to be set for the hard disk drives (up to four) installed in these workstations. From top to bottom, the pre-set SCSI IDs for hard disk drives are: 6, 5, 4, and 3. Similarly, no jumpers are installed at the factory, nor is any jumper installation required at the customer's site, on either of the hard disk drive models that are supported with the J5000 and J7000 workstations. Both hard disk drive models may be installed as is into these workstations. See the section titled "Hard Disk Drives" on page 96 for details on installing hard disk drives. 36 Chapter 2