HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 67

Troubleshooting Identifying LCD-Indicated Conditions Table 3-1. Chassis Codes for J5000 and J7000 Workstations Ostat WRN FLT TST TST FLT TST INI INI TST WRN FLT FLT FLT FLT FLT INI INI WRN FLT FLT INI Code FRU 7017 DIMM 701F DIMM 7020 SYS BD 703s DIMM 704s DIMM 705s DIMM 706s 70F0 7100 DIMM DIMM SYS BD 7101 SYS BD 7102 SYS BD 7103 SYS BD 7104 SYS BD 7105 SYS BD 7106 SYS BD 7200 DIMM 7201 7202 7203 7204 7205 DIMM SYS BD DIMM DIMM DIMM Message Description skip mem pair ck Bypass memory DIMM set check. no memory found Memory scan couldn't find any DIMMs. search for IMM Try to find a single memory bank to use for the initial memory module. DIMM s IMM vrfy DIMM s was the initial memory module last boot. Verify it still works. DIMM s IMM fail DIMM s failed the initial memory module test. DIMM s IMM test Test DIMM in slot s as the initial memory module. DIMM s is IMM DIMM s chosen as initial memory module. DIMM scan done Memory DIMM scan complete. mem register tst Start testing registers in memory controller. skip mem reg tst Bypass the memory controller register test. mem addr reg tst Firmware detected an error in the memory controller address registers. mem mbat reg tst Firmware detected an error in the memory controller bank registers. mem reg tst fail Firmware detected an error in the memory controller memory registers. mem err reg test Firmware detected an error in the memory controller error registers. mem err clr fail Firmware was unable to clear the error registers after testing. strt DIMM detect Start the Serial Presence Detection (SPD) to search for memory DIMMs. DIMM detect x% SPD is x% finished. skip DIMM detect Bypass Serial Presence Detection. unsupp DIMM type SPD found an unsupported DIMM type. SPD fatal error SPD detected an unexpected, fatal error. add HP DIMM type New HP manufactured DIMM type added to tables. Chapter 3 63