HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 12

Figures Figure 4-17. DIMM Extractor Handles 106 Figure 4-18. Screws on the Front Air Divider 108 Figure 4-19. Tie-down Straps and Screws 109 Figure 4-20. The Flex Cable Retainer 110 Figure 4-21. Arrows Indicate Where to Pull on the Ejector Handle 111 Figure 4-22. Removing the Bus Bar Shield 111 Figure 4-23. Bus Bar Thumbscrews 111 Figure 4-24. Ribbon Cable Connector Loop for Power Switch/LCD Assembly 112 Figure 4-25. Fan Cable Connector Tabs and Rear Panel Screws 113 Figure 4-26. Connecting the Flex Cable 114 Figure 4-27. Bus Bar Thumbscrews 115 Figure 4-28. Bus Bar Shield Installed 115 Figure 4-29. System Board Cooling Fans and Fan Cables 117 Figure 4-30. Removing a Fan Cable from the System Board Connector 118 Figure 4-31. Removing a Rivet 118 Figure 4-32. Fan Air Flow Arrow 119 Figure 4-33. Threading the Fan Cable 119 Figure 4-34. I/O Board 121 Figure 4-35. Removing the PCI Retainer Clip 122 Figure 4-36. I/O Slot Screw 122 Figure 4-37. I/O Board 125 Figure 4-38. Removing the PCI Retainer Clip 126 Figure 4-39. Real-time Clock Module 126 Figure 4-40. Removing the PCI Retainer Clip 128 Figure 4-41. Removing the Bus Bar Shield 128 Figure 4-42. Bus Bar Thumbscrews 129 Figure 4-43. Screws for the Power Supply on the Rear Panel 129 Figure 4-44. Screws on the Power Supply 130 Figure 4-45. SCSI Cable from the SCA Hard Disk Interface 131 Figure 4-46. Bus Bar Thumbscrews 131 Figure 4-47. Bus Bar Shield Installed 132 Figure 4-48. T-15 Torx Screws for Securing the Power Supply 132 Figure 4-49. Removing the PCI Retainer Clip 133 Figure 4-50. The Flex Cable Disconnected from the I/O Board Side 134 Figure 4-51. Screws for the I/O Board on the Rear Panel 135 Figure 4-52. SCA Hard Disk Interface 136 Figure 4-53. Removing the PCI Retainer Clip 138 Figure 4-54. Fan and Speaker Cables Connected to the I/O Board 138 Figure 4-55. Loosening the Fan/Speaker Mounting Bracket 139 8