HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 21

Front Panel Components, Components on the Front Panel with the Bezel Attached

Page 21 highlights

Product Information Front Panel Components Front Panel Components This section describes the components that are located on the front panel of the J5000 and J7000 workstations. Figure 1-1 shows the front panel components with the bezel attached. Figure 1-1. Components on the Front Panel with the Bezel Attached Bay for either one DDS-3 tape drive or floppy disk drive Power switch System LCD Bezel lock Lifting ledge Bay for one CD drive }Hard disk drive(s) (behind bezel's right-hand door) CAUTION The lifting ledge at the bottom, front of the workstation is strong enough to use as a handhold when lifting the workstation. However, note that this workstation is designated for two-person lifting; it weighs approximately 74 to 96 pounds (34 to 44 Kg), depending on the configuration. Do not attempt to lift it by yourself, or injury may result. As noted in Figure 1-1, the hard disk drives are located behind the right-hand door of the front bezel. Figure 1-2 on the next page shows the workstation with the bezel door open, so that the four hard disk drive brackets can be seen. Chapter 1 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212

Chapter 1
17
Product Information
Front Panel Components
Front Panel Components
This section describes the components that are located on the front panel of the J5000 and
J7000 workstations.
Figure 1-1 shows the front panel components with the bezel attached.
Figure 1-1.
Components on the Front Panel with the Bezel Attached
CAUTION
The lifting ledge at the bottom, front of the workstation is strong enough to
use as a handhold when lifting the workstation. However, note that this
workstation is designated for two-person lifting; it weighs approximately 74
to 96 pounds (34 to 44 Kg), depending on the configuration. Do not attempt to
lift it by yourself, or injury may result.
As noted in Figure 1-1, the hard disk drives are located behind the right-hand door of the
front bezel. Figure 1-2 on the next page shows the workstation with the bezel door open, so
that the four hard disk drive brackets can be seen.
System LCD
Power switch
DDS-3 tape drive
or floppy disk drive
CD drive
Bezel lock
}
Hard disk drive(s)
(behind bezel’s
Bay for either one
Bay for one
Lifting ledge
right-hand door)