HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 42
DDS-3 Tape Drive Optional Configuration, DDS-3 Tape Drive NSE SCSI-2 ID/Jumper Settings
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Configuration Field Replaceable Unit (FRU) Configurations DDS-3 Tape Drive (Optional) Configuration Figure 2-2 shows the NSE SCSI-2 ID/jumper settings for the optional DDS-3 tape drive. Figure 2-3 on the next page shows the switch settings for Data Compression Operation Mode for the DDS-3 tape drive. See the section titled "DDS-3 Tape Drive (Optional)" on page 101 for details on installing a DDS-3 tape drive. Figure 2-2. DDS-3 Tape Drive NSE SCSI-2 ID/Jumper Settings Bit 0 Bit 1 Bit 2 Term PWR* SCSI Connector Power Connector * Term PWR is not used in HP workstation configurations. 38 Chapter 2
38
Chapter 2
Configuration
Field Replaceable Unit (FRU) Configurations
DDS-3 Tape Drive (Optional) Configuration
Figure 2-2 shows the NSE SCSI-2 ID/jumper settings for the optional DDS-3 tape drive.
Figure 2-3 on the next page shows the switch settings for Data Compression Operation
Mode for the DDS-3 tape drive.
See the section titled “DDS-3 Tape Drive (Optional)” on page 101 for details on installing a
DDS-3 tape drive.
Figure 2-2.
DDS-3 Tape Drive NSE SCSI-2 ID/Jumper Settings
Bit 0
Bit 1
Bit 2
Term PWR*
SCSI Connector
Power Connector
* Term PWR is not used in HP workstation configurations.