Konica Minolta Fujitsu fi-6800 Operating Guide - Page 202

Chapter 9 Operational Settings Specifying the Sensitivity Level for Paper Protection [Paper Protection Sensitivity] You can specify the level of sensitivity to detect an abnormal feeding of documents when Paper Protection is enabled. Documents are deformed (e.g. warped, bent, creased) when they are not being fed by the rollers properly. To detect such a symptom and stop the scan, select [1: Low] to only detect documents that are highly deformed, and [3: High] to also detect documents that are slightly deformed. 1 Start up the Software Operation Panel. Refer to "9.1 Starting Up the Software Operation Panel" (page 170). 2 From the listing on the left, select [Device Setting 2] J [Paper Protection Sensitivity]. 3 Specify the sensitivity level for Paper Protection. Low: Decreases the sensitivity level to detect warped documents. Normal: Monitors the documents in normal sensitivity. Keep this setting for normal use. High: Increases the sensitivity level to detect warped documents. z If a paper jam occurs at feeding position frequently, select [Low]. z This setting can also be configured from the operator panel. Note that you can prioritize the operator panel setting. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 202