Konica Minolta Fujitsu fi-6800 Operating Guide - Page 210
Specifying the Area to Detect Multifeed [Document check area specification for Multifeed Detection]
View all Konica Minolta Fujitsu fi-6800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
Chapter 9 Operational Settings Specifying the Area to Detect Multifeed [Document check area specification for Multifeed Detection] The following setting is only available when you specified [Check Overlapping (Ultrasonic)]. 1 From the listing on the left, click [Device Setting 2] J [Document check area specification for Multifeed Detection]. Select the [Selected range] check box in the dialog box. 2 Specify the detection range. Range Description Selected range Select the check box to specify the detection range (colored in light blue) in the picture below. Left Middle Right 35 35 35 Detected Sheet Feeding direction Disable (Left/Middle/Right) Enable (Left/Middle/Right) Start (Left/Middle/Right) 60 60 Unit: mm Select the check box to enable the setting in this window. Clear the check box to disable the setting. Clearing this check box sets both the start and the end positions to "0", making the whole document to be detected for multifeeds. The above condition applies when the document is set to the center of the pick roller width. Does not detect multifeeds for the selected area. Detects multifeeds for the selected area. Displays the starting point of the detection by the length from the leading edge of the document. Configurable area: 0 to 510 mm (in increments of 2 mm), Start < End TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 210