ASRock Z87 Extreme11/ac LSI Mega RAID Storage Manager Guide - Page 15
Uninstalling MegaRAID Storage Manager Software, Installing and Configuring an SNMP Agent
View all ASRock Z87 Extreme11/ac manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
• VMware ESXi is supported on following operating systems: - Microsoft Windows Server - Linux RHEL - SuSE Linux Uninstalling MegaRAID Storage Manager Software You can uninstall the MegaRAID Storage Manager software by using the Uninstall command in the Program menu. See the section for your operating system for the MegaRAID Storage Manager software uninstall procedures for your specific operating system. Installing and Configuring an SNMP Agent A Simple Network Management Protocol (SNMP)-based management application can monitor and manage devices through SNMP extension agents. The MegaRAID SNMP sub agent reports the information about the RAID controller, virtual drives, physical devices, enclosures, and other items as per the SNMP request. The SNMP application monitors these devices for issues that might require administrative attention. This section describes the installation and configuration of the LSI MegaRAID SNMP agent on Linux, Solaris, and Windows operating systems. Note: The complete installation of the MegaRAID Storage Manager software installs the SNMP agent. However, you can install the SNMP agent (installer) on a system separately, without the MegaRAID Storage Manager software being installed. Prerequisite for LSI SNMP Agent RPM Installation The LSI SNMP agent application depends on the standard SNMP Utils package. Make sure that the SNMP-Util package is present in the system before you install the LSI SNMP agent RPM. The SNMP-Util package includes the RPM's net-snmp-libs, net-snmp-utils, and additional dependent RPMs. Make sure that these RPM are installed from the operating system media before you install the LSI SNMP agent RPM. Installing and Configuring an SNMP Agent on Linux This section explains how to install and configure the SAS SNMP Agent for the SuSE Linux and Red Hat Linux operating systems. To do this, perform the following steps: Note: This procedure requires that you have Net-SNMP agent installed on the Linux machine. The RPM has not been created to support -U version. The RPM -U will probably fail with this RPM. 1. Install the LSI SAS SNMP Agent using rpm -ivh . DB09-000202-05 37857-02 Installation Rev. F - May 2011 Copyright © 2011 by LSI Corporation. All rights reserved. Page 15