ASRock Z87 Extreme11/ac LSI Mega RAID Storage Manager Guide - Page 20
Prerequisites to Running MegaRAID Storage Manager Remote Administration
View all ASRock Z87 Extreme11/ac manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
The LSI-AdapterSAS.mib file is available under %ProgramFiles%\LSI Corporation\SNMPAgent\SAS directory. 3. Use a trap utility to get the traps. Note: Before you install the Agent, make sure that the SNMP Service is already installed in the system. Installing SNMP Service for Windows If you do not have the SNMP Service installed on your system, perform the following steps to install the SNMP Service for a Windows system: 1. Select Add/Remove Programs from Control Panel. 2. Select Add/Remove Windows Components in the left side of the Add/Remove Programs window. 3. Select Management and Monitoring Tools. 4. Click Next and follow any prompts to complete the installation procedure. Configuring SNMP Service on the Server Side Perform the following steps to configure the SNMP Service on the server side. 1. Select Administrative Tools from the Control Panel. 2. Select Services from the Administrative Tools window. 3. Select SNMP Service in the Services window. 4. Open SNMP Service. 5. Click the Security tab and make sure that Accept SNMP Packets from any host is selected. 6. Click the Traps tab, and select the list of host IPs to which you want the traps to be sent with the community name. Prerequisites to Running MegaRAID Storage Manager Remote Administration The MegaRAID Storage Manager software requires port 3071 and port 5571 to be open to function. Follow these steps to prepare to run the MegaRAID Storage Manager Remote Administration. 1. Configure the system with a valid IP address. Make sure that there is no IP address conflict in the sub network. Ports such as 3071 and 5571 are open and available for the MegaRAID Storage Manager framework communication. 2. Disable the security manager and the firewall. Configure the multicasting. Make sure that the Class D multicast IP addresses are registered (at least 229.111.112.12 should be registered for the MegaRAID Storage Manager software to work); if not, create a static route using the following command: Route add 229.111.112.12 dev eth1 3. Install the MegaRAID Storage Manager software. If the MegaRAID Storage Manager software is already installed, restart the MegaRAID Storage Manager framework. Page 20 DB09-000202-05 37857-02 Installation Rev. F - May 2011 Copyright © 2011 by LSI Corporation. All rights reserved.