Epson Stylus Pro 9000 Service Manual - Page 133
Platen Gap Gear Backlash Adjustment, I/H Lever Position Adjustment
View all Epson Stylus Pro 9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
EPSON Stylus Pro 9000 PLATEN GAP GEAR BACKLASH ADJUSTMENT Perform this adjustment whenever you remove or re-install the PG Motor. 1. Slightly loosen screw A as shown and fully loosen screw B. 2. Adjust the position of the motor by pivoting it at screw A so that the gear turns smoothly when rotated by hand. 3. Retighten the screws. Slightly loosen A A I/H LEVER POSITION ADJUSTMENT Perform this adjustment whenever you remove the I/H subassembly, which is located inside the Ink Cartridge Holder. 1. Raise the I/H Lever and check that the arrow mark on it points toward the center of the transmission gear as shown below. Make sure the lever is parallel with the I/C Holder wall. I/H Transmission Gear B Loosen B Make sure the I/H subassembly is positioned evenly and correctly. Make sure the arrow mark on the I/H lever points to the center of the transmission gear. 2. Also make sure that the I/H subassembly is positioned evenly and correctly, and that the lever is parallel with the wall of the I/C Holder. Adjustments 133