Epson Stylus Pro 9000 Service Manual - Page 161

EPSON Stylus Pro 9000 For paper meeting the following requirements, only the feeding operation is guaranteed: Weight 17 to 24 lb (64 to 90 gf/m2) Quality Normal, recycled paper (load short edge first portrait) Environment 59 to 77 °F (15 to 25 °C) / 40 to 60% humidity The printer exerts between 300 to 500 gf to peel off the rear edge of roll paper from the core Paper feeding is normal until the rear edge of the paper separates from the core. At the point where the rear edge is free, print quality is not guaranteed. Upper spindle last 15.75 inches (400 mm) not guaranteed Lower spindle last 11.8 inches (300 mm) not guaranteed Table 7-2. Printable Area for Roll Paper and Single Sheets Heading Roll Paper Single Sheets Paper width 7.2 to 44 in. (182 to 1,118 mm) 8.27 to 44.02 in. (297 to 1,118 mm) Paper length 8.27 to 771.65 in. (720 to 4,500 mm) 16.54 to 62.2 in. (420 to 1,580 mm) Left margin 0.12 to 0.59 in. (3 or 15 mm*) 0.12 in. (3 mm) Top margin 0.12 to 0.59 in. (3 or 15 mm*) 0.12 in. (3 mm) Right margin 0.12 to 0.59 in. (3 or 15 mm*) 0.12 in. (3 mm) Bottom margin 0.12 to 0.59 in. (3 or 15 mm*) 0.55 in. (14 mm) * The size of the margin is determined by the control panel setting. PW LM RM Paper Printable T PL B Figure 7-3. Printable Area for Single Sheets Roll paper Width Length Thickness 8.27 to 44.02 in. (210 to 1,118 mm) 28.35 to 1,771.65 in. (720 to 4,500 mm (2-inch roll: 3.9 in. (100 mm or less) / 3-inch roll: 5.9 in. (150 mm or less) 0.0026 to 0.019 in. (0.065 to 0.5 mm) Appendix 161