Yamaha LS9-32 Owner's Manual - Page 115
EQ and Dynamics, Using EQ,
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Chapter 11 EQ and Dynamics This chapter explains the EQ (equalizer) and dynamics that are provided on each channel of the LS9. About EQ and dynamics Each input channel and output channel of the LS9 provides a four-band EQ and dynamics. EQ can be used on all input channels and all output channels. An attenuator is provided immediately before the EQ, allowing you to adjust the level of the input signal. In addition, input channels provide a high-pass filter that is independent of the EQ. Input channels provide two dynamics processors. Dynamics 1 can be used as gate, ducking, compressor, or expander. Dynamics 2 can be used as compressor, compander hard, compander soft, or de-esser. Output channels provide one dynamics processor, which can be used as compressor, expander, compander hard, or compander soft. Using EQ 11 EQ and Dynamics This section explains the four-band EQ that is provided on input channels and output channels. 1 Press the SELECTED CHANNEL section [HOME] key. The SELECTED CH VIEW screen will appear in the display. 1 2 Use the LAYER section to select the desired fader layer. 3 Press a [SEL] key in the channel module section, STEREO MASTER section, or ST IN section to select the channel that you want to operate. 4 In the screen, move the cursor to the EQ popup button or any knob in the EQ field, and press the [ENTER] key. The ATT/HPF/EQ popup window will appear. In the ATT/HPF/EQ popup window you can view and edit all EQ parameters of the currently selected channel. 1 EQ popup button HINT • If you've turned on POPUP APPEARS WHEN PRESSING KNOBS in the PREFERENCE popup window (→ p. 194), you can access the above popup window by pressing either of the EQ [Q], EQ [FREQUENCY], or EQ [GAIN] encoders while the SELECTED CH VIEW screen is shown. LS9-16/32 Owner's Manual 115