Yamaha LS9-32 Owner's Manual - Page 223
Adjusting the faders (Calibration function
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
Adjusting the faders (Calibration function) Adjusting the faders (Calibration function) Depending on the environment in which you use the console, discrepancies may occur in the motion of the motor faders. You can use the Calibration function to correct these discrepancies. 1 While holding down the [SCENE MEMORY] key of the DISPLAY ACCESS section, turn on the power. After the opening screen, the following startup menu screen will appear. 1 4 Move the cursor to the START button and press the [ENTER] key. A dialog box will ask you to confirm the operation. 5 Move the cursor to the OK button of the dialog box and press the [ENTER] key. Each of the specified faders will move to the target positions in the following sequence. 1 -∞ (push down to the minimum value) B -20 dB C 0 dB D +10 dB (push up to the maximum value) 6 If there are any faders that are not in the positions shown in the screen, manually move them to the appropriate position. 1 FADER CALIBRATION button 2 Move the cursor to the FADER CALIBRATION button and press the [ENTER] key. The FADER CALIBRATION MODE popup window will appear, where you can adjust the faders. 7 When you have set all faders to the target location, move the cursor to the OK button and press the [ENTER] key. The process will proceed to the next fader position. 8 Repeat steps 6-7 to adjust the faders for positions 1 through 4. 9 When you have finished the calibration process and the APPLY button has appeared, move the cursor to the APPLY button and press the [ENTER] key. The calibration settings will be saved in internal memory. NOTE • If the RESTART button appears when calibration ends, calibration has failed. Move the cursor to the RESTART button and press the [ENTER] key to execute calibration once again. HINT • This window will also appear if a problem is detected in the fader settings while the LS9 is started up. 3 Use the top panel [SEL] keys to select the fader for which you want to perform calibration. Fader calibration is performed semi-automatically for the faders you specify using their [SEL] keys. Each fader selected by its [SEL] key is shown in red in the popup window. 10 Move the cursor to the EXIT button and press the [ENTER] key. The console will start up in normal operating mode. HINT • Alternatively, you can continue by selecting a different menu instead of using the EXIT button. 20 Other functions LS9-16/32 Owner's Manual 223