Yamaha LS9-32 Owner's Manual - Page 118
Key In Filter field Gate And Ducking, Key In Cue Gate And Ducking Only
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Using dynamics The window contains the following items. 1 2 3 6 8 4 9 5 7 1 Dynamics type buttons Use these buttons to select one of the following four types of dynamics. Input channels DYNAMICS 1 DYNAMICS 2 GATE DUCKING COMPRESSOR EXPANDER COMPRESSOR COMPANDER-H COMPANDER-S DE-ESSER Output channels DYNAMICS 1 COMPRESSOR EXPANDER COMPANDER-H COMPANDER-S HINT • For details on dynamics types, refer to the appendix at the end of this manual (→ p. 229). B Dynamics graph This graph shows the approximate response of dynamics processing. C Level meters These meters show the amount of gain reduction (GR), and the peak levels before the gate (IN) and after the gate (OUT). If the signal has overloaded, the OVER segment will light. If the corresponding channel is stereo (a ST IN channel, a MIX channel / MATRIX channel that is set to stereo, or the STEREO channel), level meters for two channels will be displayed. D DYNAMICS ON/OFF button This switches dynamics on/off. E THRESHOLD knob This specifies the threshold level at which dynamics will operate. F KEY IN SOURCE box You can select a key-in signal in this box. For details on the procedure, refer to step 6. G Other parameters This area shows other dynamics parameters. The parameters shown will depend on the currently selected dynamics type. HINT • For details on parameters, refer to the appendix at the end of this manual (→ p. 229). • You can switch dynamics on/off by moving the cursor to one of the knobs in 5 or 7 and pressing the [ENTER] key. H KEY IN FILTER field (GATE and DUCKING only) This field lets you apply a filter to the key-in signal. This field provides a FILTER box that lets you select the filter type, a Q knob (which adjusts the Q of the filter), and a FREQ knob (which adjusts the cutoff frequency or center frequency). To change the filter type, move the cursor to the FILTER BOX and use the dial or the [DEC]/[INC] keys to select either HPF (high-pass filter), BPF (band-pass filter), or LPF (low-pass filter); then press the [ENTER] key. If you select "----" in the FILTER box, no filter will be applied. NOTE • After changing the type of filter in the FILTER box, be sure to press the [ENTER] key to apply the change. I KEY IN CUE (GATE and DUCKING only) This button lets you cue-monitor the currently selected key-in signal. HINT • Even if you've selected MIX CUE mode (when all channels whose [CUE] key is on will be mixed for monitoring) as the cue mode, turning on the KEY IN CUE button will give priority to monitoring only the corresponding signal. All [CUE] keys that had been turned on at that time will be forcibly defeated. • KEY IN CUE will automatically be cancelled when you exit the corresponding screen. 5 To turn dynamics on/off, move the cursor to the DYNAMICS ON/OFF button and press the [ENTER] key. If you want to make settings in the DYNAMICS 1/ DYNAMICS 2 popup window, move the cursor to the desired button/knob and use the [ENTER] key, the dial, or the [DEC]/[INC] keys. HINT • You can also adjust the dynamics threshold by using the [DYNAMICS 1]/[DYNAMICS 2] encoders of the SELECTED CHANNEL section. 118 LS9-16/32 Owner's Manual