Yamaha LS9-32 Owner's Manual - Page 152
INC] keys to adjust the input sensitivity of, Using the buttons in the ASSIGN field
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Using talkback 2 To assign the input from the INPUT jack to talkback, move the cursor to the input select popup window in the INPUT TO TALKBACK field, and press the [ENTER] key. The INPUT PORT SELECT popup window will appear. LS9-32 3 Of the IN1-16 {1-32} buttons, move the cursor to the port you want to use for talkback, and press the [ENTER] key. To cancel the selection, press the [ENTER] key once again on the selected port. You can select only one port at a time. 4 When you've selected the port, move the cursor to the CLOSE button and press the [ENTER] key to close the popup window. 5 Connect your mic to the rear panel INPUT jack, move the cursor to the TALKBACK GAIN knob, and use the dial or the [DEC]/ [INC] keys to adjust the input sensitivity of the mic. The input level meter in the INPUT TO TALKBACK field shows the input level of the mic connected to the INPUT jack. If you want phantom power (+48V) to be supplied to the INPUT jack, turn on the +48V button in the INPUT TO TALKBACK field. NOTE • If you want to use phantom power, you must first turn ON the +48V MASTER ON/OFF button located in the SYSTEM SETUP screen. • The PAD will be internally switched on or off when the HA gain is adjusted between -14 dB and -13 dB. Keep in mind that noise may be generated if there is a difference between the Hot and Cold output impedance of the external device connected to the INPUT connector when using phantom power. 6 Using the buttons in the ASSIGN field, select the bus(es) to which you want to send the talkback signal. (You may select more than one.) The buttons correspond to the following buses. MIX 1-16 buttons MATRIX 1-8 buttons ST L, ST R, MONO buttons MIX buses 1-16 MATRIX buses 1-8 STEREO bus L/R, MONO bus HINT • If you want to clear all selections, move the cursor to the CLEAR ALL button and press the [ENTER] key. 7 To enable talkback, move the cursor to the TALKBACK ON button and press the [ENTER] key to turn it on. The TALKBACK ON button will alternate between on and off each time you press the [ENTER] key (latched operation). While talkback is on, the signal from the INPUT jack selected as the TALKBACK jack will be output to the send-destination bus. HINT • You can also assign the talkback on/off function to a userdefined key. In this case, you can choose either latched operation or unlatched operation (i.e., talkback will be On only while you hold down the key) (→ p. 196). • You can also use Talkback Dimmer to lower the monitor level of the non-talkback signals when talkback is on (→ p. 146). 152 LS9-16/32 Owner's Manual