Yamaha LS9-32 Owner's Manual - Page 210

Using cascade connections Operations on the cascade slave LS9 1 In the DISPLAY ACCESS section, press the [SETUP] key repeatedly to access the SYSTEM SETUP screen. 3 Move the cursor to the port select popup button for the bus whose port you want to assign, and press the [ENTER] key. The OUTPUT PORT SELECT popup window will appear. [ OUTPUT PORT SELECT popup window for the LS9-32 ] 2 1 LS9-32 1 1 CASCADE OUT button 2 In the MIXER SETUP field located at the lower part of the SYSTEM SETUP screen, move the cursor to the CASCADE OUT button and press the [ENTER] key. The CASCADE OUT PATCH popup window will appear. This window contains the following items. 1 2 3 1 Port select popup buttons These buttons access an OUTPUT PORT SELECT popup window where you can select the output port for each bus. B CASCADE LINK PORT field When using the Cascade Link function, this specifies the port by which control signals will be transmitted and received between the two LS9 consoles. C CASCADE COMM LINK field Here you can select the parameters and events that will be linked by the Cascade Link function. [ OUTPUT PORT SELECT popup window for the LS9-16 ] 1 This popup window contains the following items. 1 Port select buttons These buttons select the output port for the selected bus. B Slot select tabs (LS9-32 only) These tabs select slots 1/2. 4 Use the port select buttons {slot select tabs and port select buttons} to select an output port, move the cursor to the CLOSE button and press the [ENTER] key. The port will be assigned to the bus you selected in step 3. 5 Repeat steps 3 and 4 to assign output ports to other buses. NOTE • You can't assign two or more buses to the same output port. If you select a bus to which a signal route has already been assigned, the previous assignment will be cancelled. 210 LS9-16/32 Owner's Manual