Yamaha LS9-32 Owner's Manual - Page 48
Press the SELECTED CHANNEL To make HA settings for another channel
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Setup required when starting up 4 Press the SELECTED CHANNEL section [HOME] key. The [HOME] key restores the LS9's panel to its basic state (home position). When you press this key, the SELECTED CH VIEW screen will appear in the display, showing all the parameters of the channel that is selected by its [SEL] key. Also, SENDS ON FADER mode will be defeated, and the channel level function will be assigned to the faders. 1 5 Use either of the following methods to adjust the HA gain of the selected channel. ● Using the SELECTED CHANNEL section Operate the SELECTED CHANNEL section [HA GAIN] encoder. When you do so, the GAIN knob in the SELECTED CH VIEW screen will move in tandem. (If any other screen is displayed, a small popup window will show the value.) ● Using the SELECTED CH VIEW screen Use the cursor keys of the DATA ENTRY section to move the cursor to the GAIN knob in the screen, and use the dial or the [DEC]/[INC] keys to adjust the HA gain. In either case, the level of that channel is shown by the meter LEDs in the channel module section. If the meter does not move even though a signal is being input, check whether the INPUT jack is connected appropriately, and whether the meter detection point might have been set to POST ON (immediately after the [ON] key) (→ p. 155). NOTE • The PAD will be internally switched on or off when the HA gain is adjusted between -14 dB and -13 dB. Keep in mind that noise may be generated if there is a difference between the Hot and Cold output impedance of the external device connected to the INPUT connector when using phantom power. 6 To make HA settings for another channel, use the [SEL] keys to select another channel and make settings in the same way. 1 GAIN knob 48 LS9-16/32 Owner's Manual