Yamaha LS9-32 Owner's Manual - Page 156

Using the METER screen D Metering point select box Use the dial or the [DEC]/[INC] keys to select the metering point for the input/output channels. E Channel name This shows the first four characters of the channel name for the channels assigned to the [CUSTOM FADER] layer. Channels that are not assigned are shown as "----". 2 If desired, you can move the cursor to the metering point select buttons and press the [ENTER] key to switch the metering point. In the CUSTOM FADER screen, move the cursor to the metering point select box, use the dial or the [DEC]/[INC] keys to make your selection, and then press the [ENTER] key. The metering point for the level meters can be set independently for input channels and output channels. You can choose from the following metering points. ● Input channels • PRE HPF............Immediately before the highpass filter • PRE FADER .......Immediately before the fader • POST ON ...........Immediately after the [ON] key ● Output channels • PRE EQ Immediately before the attenuator • PRE FADER .......Immediately before the fader • POST ON ...........Immediately after the [ON] key For details on the metering points, refer to the block diagram at the end of this manual. 3 If you want to hold the peak levels of the level meters, move the cursor to the PEAK HOLD button and press the [ENTER] key to turn it on. On/off operations of the PEAK HOLD button will apply to both input channels and output channels. When you turn this button off, the peak level indications that had been held will be cleared. HINT • You can also assign the PEAK HOLD button on/off function to a user-defined key (→ p. 196). • If you turn on METER FOLLOW LAYER in the PREFERENCE screen, the same meter screen as the selected layer will be displayed when you press a LAYER key. 156 LS9-16/32 Owner's Manual