Yamaha LS9-32 Owner's Manual - Page 49
Making HA settings for a group of eight, channels, GAIN knob in the SELECTED CH VIEW
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Setup required when starting up ● Making HA settings for a group of eight channels Here's how to access a popup window where you can make HA settings for a group of eight channels. 1 Make sure that a mic or instrument is connected to the INPUT jack (→ p. 41). 2 Press the SELECTED CHANNEL section [HOME] key. The SELECTED CH VIEW screen will appear in the display. 1 2 1 HA popup button B GAIN knob 3 Use the keys of the LAYER section and the [SEL] keys of the channel module section to select the channel for the INPUT jack you want to control. 4 Move the cursor to the HA popup button or GAIN knob in the SELECTED CH VIEW screen, and press the [ENTER] key. The HA/PATCH popup window will appear, allowing you to adjust the HA gain, switch phantom power on/ off, and switch the phase in groups of eight channels. This popup window shows the parameters for the eight channels that include the channel you selected in step 2. 1 2 3 1 +48V button B GAIN knob C ø (phase) button HINT • If you've turned on POPUP APPEARS WHEN PRESSING KNOBS in the PREFERENCE popup window (→ p. 194), you can also access this popup window by pressing the SELECTED CHANNEL section [HA GAIN] encoder. Connections and setup 5 To adjust the HA gain, move the cursor to the GAIN knob of the desired channel in the 4 window, and use the dial or the [DEC]/[INC] keys. The input level of the channel is shown by the level meter located immediately to the right of the GAIN knob in the screen. NOTE • The PAD will be internally switched on or off when the HA gain is adjusted between -14 dB and -13 dB. Keep in mind that noise may be generated if there is a difference between the Hot and Cold output impedance of the external device connected to the INPUT connector when using phantom power. 6 To turn on phantom power for each channel, move the cursor to the +48V button in the HA field of the screen, and press the [ENTER] key. The +48V button will turn on (red), and phantom power will be supplied to the corresponding INPUT jack. NOTE • If you want to use phantom power, you must first turn ON the +48V MASTER ON/OFF button located in the SYSTEM SETUP screen. 7 To switch the phase of each channel between normal and reverse phase, move the cursor to the ø button in the HA field and press the [ENTER] key. The ø button will change from black to red, and the phase of the corresponding channel will be reversed. 8 If you want to operate the HA of a channel that is not currently shown in the popup window, use the [SEL] key to select that channel, and then make settings for it. For example if INPUT channels 1-8 are shown in the popup window, pressing the INPUT channel 9 [SEL] key will change the popup window to INPUT channels 9-16. LS9-16/32 Owner's Manual 49