Yamaha LS9-32 Owner's Manual - Page 51
Controlling the signal sent to the STE, REO bus, eight channels at a time
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Setup required when starting up 6 Raise the fader of the currently selected channel (or the encoder for a ST IN channel) to obtain an appropriate volume. In this state, you should hear sound from the speaker system patched to the STEREO channel. If you don't hear sound, watch the stereo meter located at the right of the display to see whether the LR meter is moving. ● Controlling the signal sent to the STEREO bus, eight channels at a time Here's how to access a popup window in which the level and pan/balance of the signal sent to the STEREO bus can be adjusted for eight channels at a time. 1 Press the SELECTED CHANNEL section [HOME] key. The SELECTED CH VIEW screen will appear in the display. 4 1 2 Connections and setup ● If the LR meter is moving It is possible that the output jack connected to your speaker system is not correctly patched to the STEREO channel. Check the output port patching (→ p. 95). ● If the LR meter is not moving It is possible that the channel's [ON] key is off, or that the ST button is turned off in the SELECTED CH VIEW screen. Check the setting of the [ON] key or ST button. HINT • You can also use headphones connected to the front panel PHONES OUT jack to monitor the signal that is being output from the STEREO channel (→ p. 146). 7 To adjust the pan/balance of the signal that is sent from the input channel to the STEREO bus, turn the SELECTED CHANNEL section [PAN] encoder. When you turn the [PAN] encoder, the PAN/BAL knob in the SELECTED CH VIEW screen will also move in tandem with it. You can obtain the same result by moving the cursor to the PAN/BAL knob and operating the dial or the [DEC]/[INC] keys. 8 To control another channel, use the [SEL] keys to select another channel and make settings in the same way. 1 PAN popup button B PAN/BAL knob 2 Use the keys of the LAYER section and the [SEL] keys of the channel module section to select the channel for the INPUT jack you want to control. 3 Move the cursor to the PAN popup button or PAN/BAL knob in the SELECTED CH VIEW screen, and press the [ENTER] key. The TO STEREO/MONO popup window will appear, allowing you to adjust the level and pan/balance of the signal sent to the STEREO bus, eight channels at a time. This popup window shows the parameters for the eight channels that include the channel you selected in step 2. 1 2 1 ST button B PAN/BAL knob LS9-16/32 Owner's Manual 51