Yamaha LS9-32 Owner's Manual - Page 71
Sending signals from MIX channels to the STEREO/MONO bus
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Sending signals from MIX channels to the STEREO/MONO bus Sending signals from MIX channels to the STEREO/MONO bus This section explains how to send the signal of a MIX channel to the STEREO bus or MONO bus. Signals can be sent to the STEREO bus or MONO bus in either ST/MONO mode or LCR mode, and you can choose either of these two modes for each MIX channel. These two modes differ as follows. ■ ST/MONO mode This mode sends the signal from the MIX channel to the STEREO bus and to the MONO bus independently. • The signals sent from the same MIX channel to the STEREO bus and to the MONO bus can be switched on/off individually. • The panning of the signal sent from a monaural MIX channel to the STEREO bus L/R can be operated by the 6 SELECTED CHANNEL section [PAN] encoder, or by the TO ST PAN knob in the screen. (The signal sent to the MONO bus is not affected by this encoder or knob.) • The volume balance of the signals sent from two stereo-assigned MIX channels to the STEREO bus left and right can be operated by the SELECTED CHANNEL section [PAN] encoder, or by the TO ST BAL knob in the screen. (The signal sent to the MONO bus is not affected by this knob.) Output channel operations ■ LCR mode This mode sends the signal of the MIX channel to a total of three buses (STEREO (L/R) and MONO (C)) together. • The signals sent from the same MIX channel to the STEREO bus and to the MONO bus can be switched on/off together. • The CSR (Center Side Ratio) knob in the screen adjusts the proportion of the signal level sent from the MIX channel to the STEREO (L/R) bus and the level sent to the MONO (C) bus. • The level of the signal sent from the MIX channel to the STEREO (L/R) bus and the MONO (C) bus will change according to the settings of the SELECTED CHANNEL section [PAN] encoder or the TO ST PAN knob / TO ST BAL knob in the screen. HINT • If you want to use headphones etc. to monitor the signal of the STEREO bus or MONO bus, you should press the DISPLAY ACCESS section [MONITOR] key several times to access the MONITOR (2/4) screen, and select "LCR" as the monitor source (→ p. 146) before you continue with the following procedure. 1 Press the SELECTED CHANNEL section [HOME] key. The SELECTED CH VIEW screen will appear in the display. 1 2 1 TO ST field B TO ST PAN knob (for a stereo MIX channel, the TO ST BAL knob) 2 In the LAYER section, press the LAYER [MASTER] key to select the master fader layer. 3 Press a [SEL] key in the channel module section to select the send-source MIX channel. 4 If you only want to adjust the pan or balance of the MIX channel, operate the SELECTED CHANNEL section [PAN] encoder (→ p. 86). You can obtain the same result by moving the cursor to the PAN/BAL knob in the SELECTED CH VIEW screen and operating the dial or the [DEC]/[INC] keys. LS9-16/32 Owner's Manual 71