Yamaha LS9-32 Owner's Manual - Page 58
Sending the signal from an input channel to the STEREO/MONO bus, ST/MONO mode, LCR mode
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
HA (head amp) settings • Sending the signal from an input channel to the STEREO/MONO bus 8 To switch the phase of each channel between normal and reverse phase, move the cursor to the ø button of the desired channel in the window, and press the [ENTER] key. The ø button will change from black to red, and the phase of the corresponding channel will be reversed. 9 If you want to operate the HA of a channel that is not currently shown in the popup window, use the [SEL] key to select that channel, and then make settings for it. For example if INPUT channels 1-8 are shown in the popup window, pressing the INPUT channel 9 [SEL] key will change the popup window to INPUT channels 9-16. 10 When you've finished making settings, move the cursor to the CLOSE button (or the × symbol in the upper right of the window) and press the [ENTER] key. Sending the signal from an input channel to the STEREO/MONO bus Here we will explain how to send the signal of an input channel to the STEREO bus or MONO bus. The STEREO bus / MONO bus are used to output signals to the main speakers. Signals can be sent to the STEREO bus or MONO bus in either ST/MONO mode or LCR mode, and you can choose either of these two modes for each channel. These two modes differ as follows. ■ ST/MONO mode In this mode, signals are sent independently from the input channel to the STEREO bus and to the MONO bus. • The signals sent from the same input channel to the STEREO bus and to the MONO bus can be switched on/ off independently. • The panning of the signal sent from an INPUT channel to the STEREO bus L/R can be operated by the SELECTED CHANNEL section [PAN] encoder, or by the TO ST PAN knob in the screen. (The signal sent to the MONO bus is not affected by this encoder or knob.) • The volume balance of the signal sent from a ST IN channel to the STEREO bus left and right can be operated by the SELECTED CHANNEL section [PAN] encoder, or by the TO ST BALANCE knob in the screen. (The signal sent to the MONO bus is not affected by this knob.) ■ LCR mode In this mode, the signal from the input channel is sent to three buses at once; STEREO (L/R) and MONO (C). • The signals sent from the same input channel to the STEREO bus and to the MONO bus can be switched on/ off together. • The CSR (Center Side Ratio) knob in the screen adjusts the proportion of the signal level sent from the input channel to the STEREO (L/R) bus and the level sent to the MONO (C) bus. • The level of the signal sent from the input channel to the STEREO (L/R) bus and the MONO (C) bus will change according to the settings of the SELECTED CHANNEL section [PAN] encoder or the TO ST PAN knob / TO ST BALANCE knob in the screen. HINT • If you want to use headphones etc. to monitor the signal of the STEREO bus or MONO bus, you should press the DISPLAY ACCESS section [MONITOR] key several times to access the MONITOR screen, and select "LCR" as the monitor source (→ p. 146). 58 LS9-16/32 Owner's Manual