Yamaha LS9-32 Owner's Manual - Page 54
TO MIX ON/OFF MIX MIX send on/off, DIRECT OUT INPUT channels only
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Signal flow for input channels ● INPUT PATCH This assigns input signals to the input channels. ● ø (phase) Switches the phase of the input signal. ● HPF (High Pass Filter) This is a high pass filter that cuts the region below the specified frequency. ● ATT (attenuator) Attenuates/boosts the level of the input signal. ● 4 BAND EQ (4 band equalizer) A parametric EQ with four bands; HIGH, HIGH MID, LOW MID, and LOW. ● DYNAMICS 1 This is a dynamics processor that can be used as a gating, ducking, expander, or compressor. ● DYNAMICS 2 This is a dynamics processor that can be used as a compressor, compander, or de-esser. ● LEVEL Adjusts the input level of the input channel. ● ON (on/off) Turns the input channel on/off. If this is off, the corresponding channel is muted. ● PAN This adjusts the panning of the signal sent from the INPUT channel to the STEREO bus. If necessary, this pan setting can also be applied to signals sent to two MIX buses that are assigned as stereo. ● BALANCE On ST IN channels, the BALANCE is used instead of PAN. The BALANCE adjusts the volume balance of the left/right signals sent from the ST IN channel to the STEREO bus. If necessary, you can also apply this balance setting to the signal sent to two MIX buses that are assigned as stereo. ● LCR (Left/Center/Right) This sends the signal of the input channel to the STEREO bus / MONO bus as a three-channel signal that adds a C (Center) channel to the L/R channels. ● TO MIX ON/OFF MIX (MIX send on/off) This is an on/off switch for the signal sent from the input channel to MIX buses 1-16. There are two types of MIX buses; FIXED types whose send level is fixed, and VARI types whose send level can be adjusted. You can switch between FIXED type and VARI type in sets of two adjacent odd-numbered/evennumbered MIX buses. (For details, refer to → p. 213) ● TO MIX LEVEL 1-16 (MIX send level 1-16) This adjusts the send level of the signal sent from the input channel to VARI type MIX buses 1-16. The signal sent to VARI type MIX buses can be taken from pre-EQ, prefader, or post-[ON] key as desired. The signal sent to FIXED type MIX buses is taken pre-pan if the MIX bus is monaural, or post-pan if the MIX bus is stereo. ● INSERT (INPUT channels 1-32 only) This lets you patch the desired output/input ports in order to insert an effect processor or other external device (→ p. 101). The insert-out/insert-in position can be switched between pre-EQ and pre-fader. ● DIRECT OUT (INPUT channels only) This lets you patch the desired output port in order to output the input signal directly (→ p. 103). The direct out signal can be taken from pre-HPF, pre-EQ, or pre-fader. ● METER This meters the level of the input channel. You can switch the position at which the level is detected. 54 LS9-16/32 Owner's Manual