Yamaha LS9-32 Owner's Manual - Page 69
Press a [SEL] key in the channel module, layer that contains the desired output chan
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Signal flow for output channels • Specifying the channel name / icon If the send-destination MATRIX bus is set to stereo, you can use the TO MATRIX PAN knob in the screen to adjust the panning between the two MATRIX buses. If the sendsource is the STEREO channel or a stereo MIX channel, use the TO MATRIX BALANCE knob to adjust the volume balance of the left and right channels sent to the two MATRIX buses. ● INSERT You can patch the desired output/input ports to insert an external device such as an effect processor. You can switch the insert-out and insert-in locations. ● METER This meters the level of the output channel. You can switch the position at which the level is detected. ● KEY IN (MIX channels 13-16 only) You can send the output signals of MIX channels 13-16 to the dynamics processors of each channel, and use them as key-in signals to control the dynamics. ● RACK IN PATCH This patches the output signal of a MIX channel to an input of the rack. ● OUTPUT PATCH This assigns an output port to an output channel. ● MONITOR SELECT This selects the output signal of an output channel as a monitor source. 6 Output channel operations Specifying the channel name / icon Here's how to specify the channel name and icon for each output channel. 1 Press the SELECTED CHANNEL section [HOME] key. The SELECTED CH VIEW screen will appear in the display. 2 Use the LAYER section to select the fader layer that contains the desired output channel. 4 Move the cursor to the output port select popup button in the PATCH field of the screen, and press the [ENTER] key. The PATCH/NAME popup window will appear, allowing you to select an output port and icon for the output channel, and to assign a name. 4 2 3 1 HINT • In order to select a MATRIX channel or MONO channel on the LS9-16, you must assign the channel to the custom fader layer, and then select this layer. 3 Press a [SEL] key in the channel module section or ST IN section to select the output channel that you want to operate. 21 This popup window contains the following items. 1 Output port button This indicates the output port that is assigned to the corresponding channel. If more than one output port is assigned, one port will be displayed to represent them. When you're selecting the icon or editing the channel name, moving the cursor to this button and pressing the [ENTER] key will take you back to the output port selection screen. 1 PATCH field B Output port select popup button LS9-16/32 Owner's Manual 69