Yamaha LS9-32 Owner's Manual - Page 144
Channel display field, FADE TIME knob, SET ALL button, To turn on the Fade function, move the cur
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Using the Fade function 2 Make sure that the cursor is located somewhere other than the constant display area, and use the dial or the [DEC]/[INC] keys to select the scene for which you want to make Fade function settings. 3 Move the cursor to the SET popup button, and press the [ENTER] key to access the FADE TIME popup window. In this popup window you can select the channels to which Fade will be applied, and adjust the fade time. 1 3 2 4 1 Channel display field The channels to which Fade is applied are highlighted. B FADE TIME knob This knob sets the fade time. Move the cursor to this knob and use the dial or the [DEC]/[INC] keys to adjust the setting. C SET ALL button If you press this button, the Fade effect will be enabled for all faders/encoders of that scene. D CLEAR ALL button If you press this button, the Fade effect will be disabled for all faders/encoders of that scene. 4 Press the [SEL] keys of the desired channels to select the channels to which the Fade effect will be applied (multiple selections are allowed). The [SEL] keys of the selected channels will light, and those channels will be highlighted in the channel display field of the popup window. You can cancel a selection by pressing a lit [SEL] key once again to make it go dark. 5 Move the cursor to the FADE TIME knob, and use the dial or the [DEC]/[INC] keys to adjust the fade time. The range is 0.0 sec-60.0 sec. When you've finished making settings, move the cursor to the OK button and press the [ENTER] key to close the FADE TIME popup window. HINT • The fade time you specify here is used for all channels selected in step 4. 6 To turn on the Fade function, move the cursor to the FADING button and press the [ENTER] key. The Fade on/off setting is made individually for each scene. Save the scene if necessary. HINT • Scenes for which Fade settings are made are shown by a "FADING" indication in the STATUS field of the SCENE LIST screen. 7 Make Fade function settings for other scenes as described in steps 2-6. 8 Recall a scene for which the Fade function is turned on. The faders will begin to move immediately after Recall occurs, and will reach the values of the recalled scene over the course of the specified fade time. NOTE • The Fade function settings can be applied individually even if faders are linked by Channel Link. HINT • If you stop a moving fader while you hold down the corresponding [SEL] key, the fade effect will stop at that point. • If you recall the same scene while faders are moving, all channel faders will move immediately to their target positions. 144 LS9-16/32 Owner's Manual