Yamaha LS9-32 Owner's Manual - Page 216
Setting the network address, NETWORK field, NETWORK SET button, MAC ADDRESS field
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 216 highlights
Setting the network address Setting the network address Here's how to set the network address that will be required when you use the LS9's NETWORK connector to connect it to a Windows computer. NOTE • The network address can be changed only by users who have administrative privileges. • For details on network settings, refer to the LS9 Editor installation guide which can be downloaded from the following Yamaha website. http://www.yamahaproaudio.com/ 1 In the DISPLAY ACCESS section, press the [SETUP] key repeatedly to access the MISC SETUP screen. 1 2 3 LS9-32 1 NETWORK field This shows the values of network-related parameters. B NETWORK SET button This accesses the NETWORK popup window, where you can make network-related settings. C MAC ADDRESS field This is the MAC (Machine Access Control) address specified for identifying a host within a network. This field is only for display, and cannot be edited. 2 Move the cursor to the NETWORK SET button in the NETWORK field, and press the [ENTER] key to access the NETWORK popup window. 1 3 2 4 1 IP ADDRESS field This is a number (IP address) assigned to identify each device on the Internet or within an LAN (Local Area Network). B GATEWAY ADDRESS field This specifies the number (gateway address) that identifies a device (gateway) that allows data of differing media or protocol to be exchanged within a network to allow communication. C SUBNET MASK field This defines the number of bits (of the IP address used within the network) that will be used as the network address that distinguishes the network. D LINK MODE field Select either 100BASE-TX (transmission speed: maximum 100 Mbps) or 10BASE-T (transmission speed: max 10 Mbps) as the specification used for communication via the NETWORK connector. 3 Move the cursor to the LINK MODE field, and use the dial or the [DEC]/[INC] keys to select a communication protocol for the NETWORK connector as appropriate for the network to which the LS9 is connected. NOTE • Be aware that if the specification does not match, communication will not occur correctly. 4 Move the cursor to each remaining field in the screen, and use the dial or the [DEC]/ [INC] keys to specify each address. If you are connecting the LS9 to your computer in a one-to-one connection, we recommend that you make the following initial settings. ● IP address 192.168.0.128 or similar (it must not conflict with the IP address of any other device on the network) ● Gateway address 192.168.0.1 or similar (it must not conflict with the IP address of any other device on the network) ● Subnet mask 255.255.255.0 or similar 216 LS9-16/32 Owner's Manual