Yamaha LS9-32 Owner's Manual - Page 184
CONTROL CHANGE MODE field, CLEAR ALL button, INITIALIZE ALL button, MODE field, PARAMETER 1/2 field
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
Using control changes to control parameters B CONTROL CHANGE MODE field Here you can select the control change transmission/ reception mode. This setting is linked with the CONTROL CHANGE MODE field of the MIDI SETUP popup window. C List This list shows the event (fader/encoder pattern, [ON] key on/off operation, etc.) assigned to each control number. ● NO. This indicates the control number. You can use control numbers 1-31, 33-95, and 102-119. ● CONTROL CHANGE EVENT Indicates/selects the type of event assigned to each control number. When you press the popup button for an event, the CONTROL CHANGE EVENT popup window will appear, allowing you to change the control number assignment. D CLEAR ALL button Pressing this button will clear all event assignments in the list. E INITIALIZE ALL button Pressing this button will restore all event assignments in the list to their default state. 7 Use the buttons of the CONTROL CHANGE MODE field to select the control change transmission/reception mode. You can choose one of the following two modes for control change transmission/reception. ● NRPN mode (when the NRPN button is on) The LS9's various mix parameters will be transmitted and received on a single MIDI channel as NRPN messages. If you select this mode, the assignments in the list will be ignored. ● TABLE mode (when the TABLE button is on) The LS9's various mix parameters will be transmitted and received on a single MIDI channel as control change messages. HINT • The channel on which control changes are transmitted and received is specified by the MIDI SETUP popup window PORT/CH field (→ p. 178). 8 Use the buttons of the CONTROL CHANGE field to turn transmission and reception on/ off, and make settings for echo output. Each button has the following function. ● Tx button Switches control change transmission on/off. ● Rx button Switches control change reception on/off. ● ECHO button This selects whether incoming control changes are echoed-out from the transmission port. 9 To change the event assignment for each control number, move the cursor to the popup button for the corresponding event in the list, and press the [ENTER] key. The CONTROL CHANGE EVENT popup window will appear. In this window you can specify the event assigned to each control number. The window contains the following items. 1 2 1 MODE field Select the type of event. B PARAMETER 1/2 field In conjunction with the MODE field, this specifies the type of event. NOTE • If NRPN mode is selected as the control change transmission/reception mode, the settings in this window are ignored. HINT • For details on the events that can be assigned to control changes, refer to the appendix (→ p. 249). 10 In the order of the MODE field → PARAMETER 1 field → PARAMETER 2 field, specify the type of event you want to assign. To select an item, use the dial or the [DEC]/[INC] keys. Move the cursor to the OK button and press the [ENTER] key to finalize the changes and close the CONTROL CHANGE EVENT popup window. 11 Assign events to other control numbers in the same way. When you operate the parameters you assigned on the LS9, control change messages will be transmitted to external devices. Similarly, if the corresponding control change messages are sent from an external device on the appropriate channel, the parameters assigned to those control numbers will change. HINT • You can use the CLEAR ALL button to erase all assignments to control numbers. The INITIALIZE ALL button will return all control number assignments to their default state. • Assignments to control numbers are maintained as settings for the entire system, rather than for individual scenes. 184 LS9-16/32 Owner's Manual