Yamaha LS9-32 Owner's Manual - Page 84
Adjusting the send levels from a spe, cific channel to the MIX buses / MATRIX, buses
View all Yamaha LS9-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Operations in the SELECTED CHANNEL section Subsequent operations will differ depending on the parameters you want to adjust. ● Adjusting the send levels from a specific channel to the MIX buses / MATRIX buses Use the SEND field when you want to send the signal from an INPUT/ST IN channel to a MIX bus, or from a MIX, STEREO, or MONO channel to a MATRIX bus. 1 2 1 SEND popup button This accesses a popup window where you can make send level settings for eight channels at a time. B TO MIX LEVEL (TO MATRIX LEVEL) knobs These knobs indicate the send level of the signal sent from that input channel to each MIX bus or MATRIX bus. If the send-destination MIX bus / MATRIX bus is set to stereo, the left knob of the two adjacent knobs will operate as a PAN knob. (For a ST IN channel, a stereo MIX channel, or STEREO channel, it will operate as the BALANCE knob.) To adjust the send level to a MIX bus / MATRIX bus, use the keys of the MIX/MATRIX SELECT section to select the send-destination bus, and use the SELECTED CHANNEL section [SELECTED SEND] encoder. (Alternatively, move the cursor to the TO MIX LEVEL/TO MATRIX LEVEL knob in the screen, and operate the dial or the [DEC]/[INC] keys.) If desired, you can use the TO MIX ON/OFF buttons to switch the signal sent to each bus on/off (if the MIX bus is the FIXED type). At the left side of these buttons is shown the position from which the signal is sent from the current channel. (For details on changing the send position → p. 213) HINT • If you want to make send level settings for eight channels at a time, use the SEND popup button in the screen to access the popup window (→ p. 64). • If you've turned on POPUP APPEARS WHEN PRESSING KNOBS in the PREFERENCE popup window (→ p. 194), you can also access the above popup window by pressing the SELECTED CHANNEL section [SELECTED SEND] encoder. • You can access the SEND popup window by moving the cursor to the To MIX SEND knob of a VARI type, and pressing the [ENTER] key. • For MIX buses that are set to STEREO, the left knob indicates the PAN of the MIX SEND, and the right knob indicates the SEND LEVEL. 3 C TO MIX ON/OFF button If the send-destination MIX bus is a FIXED type, the TO MIX LEVEL knob will not appear; instead, the TO MIX ON/OFF button will be shown. By moving the cursor to the TO MIX ON/OFF button and pressing the [ENTER] key, you can turn the signal sent from that channel to the MIX button on/off. 84 LS9-16/32 Owner's Manual