HP Cluster Platform Interconnects v2010 Quadrics QsNetII Interconnect - Page 118

": ..." When communication is established with a interconnect module, basic configuration information is logged to syslog. ": swmserver restarted" This message indicates that communication with an interconnect module is established (such as after the swmserver process is restarted). ": heartbeat" Every five minutes, each interconnect module sends out this heartbeat message, indicating that it is functioning. ": problem: updates have stopped" This message indicates that swmlogger has received no communication from an interconnect module for 20 minutes. ": problem: inconsistent firmware revision" This message indicates that swmlogger has detected a interconnect module with an inconsistent firmware revision. It compares firmware revisions to that of the first module that signs in. ": problem: power/control problem" This message indicates that an interconnect module of an unknown type has tried to establish communication with swmlogger. ": link B:C:L: " Link messages are identified as board B, chip C, and link L. Common messages in the log file are: • link in reset • link ok Theses message occur when the PCI card driver forces the link into reset each time a node reboots. ": psu: " This message indicates the power supply module status, which can be on or off. ": fan: " This message indicates fan speed changes. Only changes of 50 RPM or more are reported. ": temp: " This message indicates module temperature changes. Only changes of 2 degrees Celsius or more are reported. ": hotplug: " This message indicates hot-pluggable board insertion or removal, such as board removed from slot slot id or board inserted in slot slot id. 12-16 Maintenance and Diagnostic Procedures