Kyocera KM-2030 Fax System (B) Instruction Handbook - Page 112

Section 4 Other Features of this Fax 14. Enter the subaddress you want to use for this F-Code Based Transmission. * The subaddress can be up to 20 digits in length and can include any combination of the numerals 0 - 9. SubAddress: 6635 20 Digits (Inch) Enter SubAddress. Subaddress: 6635 20 digits Enter subaddress numbers (Metric) 15. Press the Enter key. Password: 20 Digits Enter Your Password 16. If necessary, enter the predetermined F-Code password. * The password can be up to 20 digits in length and can include any combination of the numerals 0 - 9 and the symbols " " and "#". You do not have to enter an F-Code password here if you agree in advance with the destination party not to use one. * If you DO NOT need to enter an F-Code password, proceed to step 17. Password: 3856 20 Digits Enter Your Password 17. Press the Enter key. * If there is some problem with the information that you entered, an error message will appear in the message display. In this case, press the Enter key and the message display will return to a display that allows you to enter the destination fax number again. 18. Enter a name for the program. * The program name can be up to 20 characters in length. (Refer to "Entering characters", page 1-30.) M.K.G. Enter Program Name 19. Press the Enter key. The entered information will become registered under the designated program key. > If you want to continue registering other program keys, return to step 4, page 4-29. > If you are finished registering program keys, press the Reset key. The operation panel will return to the initial mode settings. 4-30 B. Broadcast Transmission (Continued from step 5, page 4-29) 6. Use the cursor up or the cursor down key to select "Broadcast". ProgramKey:05:Select Mode Send Á Broadcast RX Polling (Inch) Program:05:Select mode Send Á Broadcast RX polling (Metric) 7. Press the Enter key. Delayed Comm.: Á On Off 8. Use the cursor up or the cursor down key to select whether or not you want to designate a time for the transmission to begin. > If you want to designate a time for the transmission to begin, select "On" and proceed to step 9. > If you want to have the transmission begin immediately after the program key is pressed, select "Off" and proceed to step 11. 9. Press the Enter key. 10. Use the keypad to enter the desired time for the transmission to begin. * If you want to reset the displayed time to "00:00", simply press the Stop/Clear key. TX Time:17:00 (Inch) Enter TX Time TX time:17:00 (Metric) Enter transmission time 11. Press the Enter key. v: Enter Fax No. v: Enter fax number (Inch) (Metric) 12. Enter a destination fax number. * You can enter the fax number using the keypad, abbreviated numbers, one-touch keys, group dial keys or the directory. Chain dial keys can be used as well. If you enter the fax number using an abbreviated number or one-touch key that is already designated for F-Code Based Communication, you can skip steps 13 through 16. 13. If you want to designate the communication for this fax number as an F-Code Based Transmission, press the F-Code [SUBADDRESS] key. > If you pressed the F-Code [SUBADDRESS] key, proceed to step 14 on pape 4-31. > If you DID NOT press the F-Code [SUBADDRESS] key, proceed to step 17 on pape 4-31.