Kyocera KM-2030 Fax System (B) Instruction Handbook - Page 117

Password Check Communication Password Check Communication allows you to limit to and from whom fax communication can be accomplished but making it necessary to meet specific conditions regarding certain passwords. More specifically, the passwords (Permit Telephone Number and Permit ID) are registered in advance and Password Check Communication is turned ON. No special settings are required during the operation to transmit or receive faxes. When actual transmission or reception of documents begins, communications that satisfy the specific password conditions will be carried out and communications that do not satisfy these conditions will result in an error. Section 4 Other Features of this Fax * Prior to using Password Check Communication, carefully read "" and "" below in addition to consulting with those party's that will have access to password privileges. * You must register the desired password (Permit Telephone Number and/or Permit ID) in your fax in advance. * The other party must register its self-station fax number or self-station ID in advance. * In order to use Password Check Communication, it is necessary to turn it ON in advance. Refer to "(5) Password Check Transmission ON/OFF", page 4-39, and "(6) Password Check Reception ON/OFF", page 4-40. • The Permit Telephone Number registered in your fax must match the self-station fax number registered in the other party's fax. • The Permit ID registered in your fax must match the self-station ID registered in the other party's fax. • When you are transmitting documents and the other party's fax number is dialed with an abbreviated number or one-touch key, the last 4 digits of the registered number must match the last 4 digits of the other party's self-station fax number (not applicable with Manual Fax Transmission). • When you are receiving documents, the last 4 digits of a fax number registered under one of your abbreviated numbers or one-touch keys must match the 4 digits of the transmitting party's self-station fax number. (1) Registering Permit Telephone Numbers * You can register up to 5 numbers as Permit Telephone Numbers in this fax. * If you want to cancel the procedure part way through, press the Reset key. The operation panel will return to the initial mode settings. JUL-08-2001 12:00 Set Document (Inch) 08-JUL-2001 12:00 (Metric) Set original 1. Raise the cover plate and press the Register key. The "Program" menu will appear in the message display. (Inch) (Metric) Program: End Á Program Abbreviated Dial Program 1-Touch Key Program: End Á Program abbreviated dial Program one-touch key (Inch) (Metric) 2. Use the cursor up or the cursor down key to select "Program Fax Parameter". Program: Program encryption box Program Encryption ID Á Program Fax Parameter (Inch) P Program: Encryp. code box regist. Program encryption code (Metric) Á Program fax parameter P 4-35