Kyocera KM-2030 Fax System (B) Instruction Handbook - Page 169

Section 8 Reference Information Error Code Tables When a communications error occurs, one of the following error codes will be printed out on the corresponding Transmission Report or Reception report as well as the Activity report. Refer to the following tables for a more detailed explanation of the error. * If an error occurs during communication at a transmission speed of 33600 bps, the "U" in the error codes noted below will change to an "E". CODE CAUSE AND/OR PROCEDURE FOR CORRECTION Busy (U00000) Stopped (U00100) Stopped (U00200) The line is busy or the other party does not answer after automatically redialing the set number of times. Perform transmission or reception procedures again. Transmission has been interrupted by pressing the Stop/Clear key. Reception has been interrupted by pressing the Stop/Clear key. U00300 The destination fax has run out of recording paper. Check with the destination party. U00420 U00462 Stopped (U00500) U00600 U00690 Connection was made on a call initiated by the transmitting party, but the transmission has been interrupted because the transmitting party does not possess the necessary communication capabilities. During multiple communication (Broadcast transmission, Polling reception, etc.), this unit was unable to transmit to all destinations due to a communications interruption. Communication was interrupted due to trouble with your unit. Perform transmission or reception procedures again. U00700 Communication was interrupted due to trouble with the other party's fax unit. Check with the other party. U00800 U00810 U00900 U00910 U01000 U01080 U01100 U01199 U01400 Unsuccessfully transmitted page(s) remain. Perform transmission procedures again. Unsuccessfully received page(s) remain. Perform reception procedures again. A communication error occurred during transmission. Perform transmission procedures again. A communication error occurred during reception. Perform reception procedures again. A communication which uses the timer was scheduled, and a number was entered using an abbreviated number or one-touch key, etc., but communication with that party was impossible because that number was no longer registered when the scheduled time arrived. Check your unit. U01500 A communication error occurred during transmission at high transmission speed. Perform transmission procedures again. U01600 A communication error occurred during reception at high transmission speed. Perform reception procedures again after having the transmitting party lower the transmission speed. U01700 U01720 A communication error occurred during transmission at high transmission speed. Perform transmission procedures again. 8-9