Kyocera KM-2030 Fax System (B) Instruction Handbook - Page 28

Section 1 Basic Use of this Fax Sending Documents The following contains explanations on the standard method for transmitting documents. Carefully read all the notes regarding acceptable documents, etc., to ensure correct operation. Switching to the Fax Operation mode 1 Press the COPY/FAX switching key to switch to the Fax Operation mode. * When the FAX indicator is lit, the machine is in the Fax Operation mode. (Inch) (Metric) * Check the message display to make sure that the operation panel is in the initial mode for fax operation. If the operation panel is not in the initial mode, press the Reset key. JUL-08-2001 12:00 (Inch) Set Document 08-JUL-2001 12:00 (Metric) Set original Selecting the transmission mode 2 Select the desired transmission mode. * There are two transmission modes available in this fax: Memory Transmission and Direct Feed Transmission. Memory Transmission is the default setting in this fax and, in this case, the Memory Tx. indicator will be lit. (Inch) (Metric) * To switch between the Memory Transmission and Direct Feed Transmission modes, press the Memory Tx. key. (Inch) (Metric) * It is also possible to select which transmission mode will be the default setting for the initial mode. Refer to "Setting the Default Transmission Mode", page 6-15. * If the Memory Tx. indicator is NOT lit, the fax is in the Direct Feed Transmission mode. (Inch) (Metric) 1-20