Kyocera KM-2030 Fax System (B) Instruction Handbook - Page 148
Making Volume Settings
View all Kyocera KM-2030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Section 6 Various Settings and Registration in this Fax Making Volume Settings The volume of the alarm, the monitor and the speaker can be adjusted here, or you can make the alarm inaudible. Sets the volume of the alarm that sounds in the event of an error or when you press an incorrect key on the operation panel. Sets the volume of the internal speaker that allows you to listen to conditions on the telephone line when the On-Hook key was NOT pressed. Sets the volume of the internal speaker that allows you to listen to conditions on the telephone line when the On-Hook key WAS pressed. * If you want to cancel the procedure part way through, press the Reset key. The operation panel will return to the initial mode settings. JUL-08-2001 12:00 Set Document (Inch) 08-JUL-2001 12:00 Set original (Metric) 1. Raise the cover plate and press the Configure key. (Inch) (Metric) 4. Use the cursor up or the cursor down key to select which volume setting you want to make. > If you selected "Buzzer Volume"... 1 Press the Enter key. Buzzer Volume: Á Off *Small Large 2 Use the cursor up or the cursor down key to select the desired volume. * The volume can be set to any one of 3 settings: "Off", "Small" or "Large". If you selected "Off", you will not be able to hear the alarm. > If you selected "Monitor Volume"... 1 Press the Enter key. Monitor Volume: Á Off Small *Medium 2 Use the cursor up or the cursor down key to select the desired volume. * The volume can be set to any one of 4 settings: "Off", "Small", "Medium" or "Large". If you selected "Off", you will not be able to hear the monitor. > If you selected "Speaker Volume"... 1 Press the Enter key. Speaker Volume: Á Off *Small Medium Set Fax: End Á Line Type TTI :Tone Dial (Inch) :Outside P. Set fax: End Á TTI Print report :Outside p. (Metric) P 2. Use the cursor up or the cursor down key to select "Set Volume". Set Fax: #Rings(AutoRX): 2Times Dial Confirm :On Á Set Volume (Inch) P Set fax: Nr rings-TAD Confirm dial Á Set volume :10Times :On 3. Press the Enter key. Set Volume: End Á Buzzer Volume :Small Monitor Volume:Medium (Metric) P 6-8 2 Use the cursor up or the cursor down key to select the desired volume. * The volume can be set to any one of 4 settings: "Off", "Small", "Medium" or "Large". If you selected "Off", you will not be able to hear the monitor. 5. Press the Enter key. The message display will return to the "Set Volume" menu. Set Volume: End Á Buzzer Volume :Large Monitor Volume:Small > If you want to perform other setting procedures, select "End" and then press the Enter key. > If you are finished making settings, press the Reset key. The operation panel will return to the initial mode settings.