Kyocera KM-2030 Fax System (B) Instruction Handbook - Page 12

Section 1 Basic Use of this Fax (Inch version) (Right portion, with cover plate lowered) (Metric version) (Left portion) ^ Memory Tx. [MEMORY TX.] indicator...When this indicator is lit, the fax is in the Memory Transmission mode. When the indicator is out, the fax is in the Direct Feed Transmission mode. & On-Hook [ON-HOOK] indicator...When a separately purchased telephone is connected to this fax machine and this indicator is lit, the On-Hook [ON-HOOK] key has been pressed while the telephone receiver is still "on the hook", thereby enabling dialing without the need to pick up the receiver. * TAD [MESSAGE TEL.] indicator...When this indicator is lit, the fax is in the TAD Reception mode. ( Auto Rx. [MANUAL RX.] indicator • Inch version: When this indicator is lit, the fax is in the Auto Fax Reception mode. • Metric version: When this indicator is lit, the fax is in the Manual Fax Reception mode]. ) Memory Tx. [MEMORY TX.] key...Press this key when you want to switch between the Memory Transmission and Direct Feed Transmission modes. ⁄ On-Hook [ON-HOOK] key...When a separately purchased telephone is connected to this fax machine, press this key when you want to dial without picking up the telephone receiver. ¤ Pause/Redial [PAUSE/REDIAL] key...Press this key when the fax is in the Direct Feed Transmission mode and you want to have the fax automatically redial the most recently dialed number. Press this key also while entering a fax number when you want to insert a pause of a few seconds at that point in dialing. A pause is indicated by a dash ( - ) in the message display. ‹ Abbr./Directory [ABBR./DIRECTORY] key...Press this key when you want to dial with abbreviated numbers or you want to access the directory. › One-touch keys (No. 1 - No. 32)...32 one-touch keys are available for use with this fax. Lower the cover plate when you want to access one-touch keys No. 1 - No. 20 and raise the cover plate in order to access one-touch keys No. 21 - No. 32. You can designate each of the keys to function as either a one-touch key, a program key, a group dial or a chain dial key. Use these keys as well during the registration of destination names, etc. fi Resolution select key...Press this key when you want to select the degree of resolution at which the documents will be transmitted. fl Resolution indicators...Select among the 5 available resolution settings: Normal, Fine [FINE], Super Fine [SUPER FINE], Ultra Fine [ULTRA FINE] and Half Tone [PHOTO MODE]. Ordinarily, all of the resolution indicators will be out; and the Normal resolution is thus selected. If you want to use any resolution other than Normal, press the resolution select key until the resolution indicator that corresponds to the desired resolution is lit. ‡ Contrast select keys...Press these key when you want to select the degree of contrast, darker or lighter, at which the documents will be scanned. ° Contrast indicators...These indicators display the 3 available levels of scanning contrast. Ordinarily, the middle indicator will be lit. If you want to increase (darken) the contrast at which documents are scanned, press the right contrast select key to move the lit indicator towards the number "5". If you want to reduce (lighten) the contrast at which documents are scanned, press the left contrast select key to move the lit indicator towards the number "1". · Machine Error indicator...When this indicator is lit, a paper jam or a mechanical error has occurred. 1-4