Yamaha QL5 Reference Manual - Page 193

DANTE SETUP window (SETUP page) 1 2 3 5 4 6 8 7 1 STATUS indicators Show the operating status of the QL series console and the Dante network. 2 CONSOLE ID select buttons Set the IDs for the QL series consoles. If five or more QL units are connected to a network, and you plan not to assign IDs to some of the units, press the OFF button of each of those units to turn off the ID. 3 SECONDARY PORT select buttons Specify how the Dante audio network is configured. 4 CANCEL button When editing the CONSOLE ID or SECONDARY PORT settings, you can press this button to cancel the changes you made. 5 APPLY button After changing the CONSOLE ID or SECONDARY PORT settings, press this button to apply the changes you made. Setup 6 BIT select buttons Enable you to set the audio bit depth to 24-bit or 32-bit. • 24bit Use this when transmitting and receiving data to or from an Rio unit. When using a QL series system, you will normally use this setting. • 32bit This is effective when transmitting and receiving 25-bit or larger data (when using cascade or gain compensation), but the amount of data being transmitted will increase 20-30% compared to 24bit. 7 LATENCY select buttons Enable you to set the Dante audio network latency to 0.25 ms, 0.5 ms, 1.0 ms, 2.0 ms, or 5.0 ms. The latency setting varies depending on the network connection method and size. For details, refer to "Setting the Dante audio network latency" on page 194. 8 DANTE PATCH BY select buttons Use these select buttons when using Dante Controller to make Dante patch settings. If the THIS CONSOLE button is selected, the DANTE INPUT PATCH and DANTE OUTPUT PATCH settings can be edited from the QL series console. If the DANTE CONTROLLER button is selected, it will not be possible to edit the Dante patch settings. You can operate these buttons regardless of the state of the DANTE PATCH BY select buttons on other QL series consoles on the network. NOTE • Settings that are shared with the I/O device (BIT/LATENCY/W.CLOCK) will reflect the settings of the QL series console whose CONSOLE ID is set to #1. • If the DANTE CONTROLLER button is selected in the DANTE PATCH BY section, and you attempt to edit the Dante patching or related settings, the message "This Operation is Not Allowed" will appear at the bottom of the screen. • DANTE patch information is applied to the device if the QL settings file (file name extension .CLF) is loaded under the following conditions. Otherwise, the information is not applied and the current state will be maintained. • In the SAVE/LOAD window (page 177), the WITH DANTE SETUP AND I/O DEVICE button is on. • Either #1, #2, #3, or #4 CONSOLE ID select button is on. • The THIS CONSOLE button of the DANTE PATCH BY select buttons is on. 193 Reference Manual