Yamaha QL5 Reference Manual - Page 236

 DISTDELAY One input, two output distortion and delay effects in series. Parameter Range DST TYPE DST1, DST2, OVD1, OVD2, CRUNCH DRIVE 0-100 MASTER 0-100 TONE -10 to +10 N. GATE 0-20 SYNC OFF/ON DLY.NOTE *1 MOD.NOTE *2 DELAY 0.0-2725.0 ms FB. GAIN -99 to +99% HI. RATIO FREQ. DEPTH 0.1-1.0 0.05-40.00 Hz 0-100% DLY.BAL 0-100% Description Distortion type (DST = distortion, OVD = overdrive) Distortion drive Master volume Tone control Noise reduction Tempo parameter sync on/off Used in conjunction with TEMPO to determine DELAY Used in conjunction with TEMPO to determine FREQ Delay time Feedback gain (plus values for normal-phase feedback, minus values for reverse-phase feedback) High-frequency feedback ratio Modulation speed Modulation depth Distortion and delay balance (0% = all distortion, 100% = all delayed distortion) *1. setting) *2. (Maximum value depends on the tempo  MULTI FILTER Two input, two output 3-band multi-filter (24 dB/octave). Parameter TYPE 1 FREQ. 1 LEVEL 1 RESO. 1 TYPE 2 FREQ. 2 LEVEL 2 RESO. 2 TYPE 3 FREQ. 3 LEVEL 3 RESO. 3 Range LPF, HPF, BPF 28.0 Hz-16.0 kHz 0-100 0-20 LPF, HPF, BPF 28.0 Hz-16.0 kHz 0-100 0-20 LPF, HPF, BPF 28.0 Hz-16.0 kHz 0-100 0-20 Description Filter 1 type: high pass, low pass, band pass Filter 1 frequency Filter 1 level Filter 1 resonance Filter 2 type: high pass, low pass, band pass Filter 2 frequency Filter 2 level Filter 2 resonance Filter 3 type: high pass, low pass, band pass Filter 3 frequency Filter 3 level Filter 3 resonance  FREEZE One input, two output basic sampler. Parameter Range REC MODE MANUAL, INPUT REC DLY -1000 to +1000 ms PLY MODE MOMENT, CONTI., INPUT TRG LVL -60 to 0 dB TRG MASK 0-1000 ms START END LOOP LOOP NUM PITCH FINE MIDI TRG START [SAMPLE] END [SAMPLE] LOOP [SAMPLE] *1 *1 *1 0-100 -12 to +12 semitones -50 to +50 cents OFF, C1-C6, ALL 0-131000 0-131000 0-131000 Description In MANUAL mode, recording is started by pressing the REC and PLAY buttons. In INPUT mode, Record-Ready mode is engaged by pressing the REC button, and actual recording is triggered by the input signal. Recording delay. For plus values, recording starts after the trigger is received. For minus values, recording starts before the trigger is received. In MOMENT mode, the sample plays only while the PLAY button is pressed. In CONT mode, playback continues once the PLAY button has been pressed. The number of times the sample plays is set using the LOOP NUM parameter. In INPUT mode, playback is triggered by the input signal. Input trigger level (i.e., the signal level required to trigger recording or playback) Once playback has been triggered, subsequent triggers are ignored for the duration of the TRG MASK time. Playback start point in milliseconds Playback end point in milliseconds Loop start point in milliseconds Number of times the sample plays Playback pitch shift Playback pitch shift fine The PLAY button can be triggered by using MIDI Note on/off messages. Playback start point in samples Playback end point in samples Loop start point in samples *1. 0.0-5941.0 ms (fs=44.1 kHz), 0.0 ms-5458.3 ms (fs=48 kHz)  DISTORTION One input, two output distortion effect. Parameter DST TYPE DRIVE MASTER TONE N. GATE Range DST1, DST2, OVD1, OVD2, CRUNCH 0-100 0-100 -10 to +10 0-20 Description Distortion type (DST = distortion, OVD = overdrive) Distortion drive Master volume Tone control Noise reduction 17 Data List