Yamaha QL5 Reference Manual - Page 7

If the destination bus channels are two mono channels: 1 2 3 1 SEND knob Adjusts the send level to the corresponding bus. 2 PRE indicator Indicates the send point of the corresponding bus. If the PRE button on the MIX SEND 8ch screen is turned ON, this PRE indicator will be turned on. 3 ON button Switches the send signal to the corresponding bus on or off. If the destination bus is a stereo channel: 1 2 3 1 SEND/PAN knob The right-hand knob adjusts the level of the signal sent to a pair of bus channels (evennumbered and odd-numbered). The left-hand knob adjusts the pan and balance of the same signal. 2 PRE indicator Indicates the send point of the corresponding bus. If the PRE button on the MIX SEND 8ch screen is turned ON, this PRE indicator will be turned on. 3 ON button Switches the send signal to the two buses on or off. NOTE • If the indices of a SEND/PAN knob are white, the send point is assigned as PRE; if the indices are black, it is assigned as POST. • If the send point is PRE, you can specify the PRE point as either VARI [PRE EQ] or VARI [PRE FADER] in the BUS SETUP popup that appears when you press the SETUP button  BUS SETUP button. • If the type of the destination bus is set to FIXED, controllers 1-2 mentioned above will not be displayed. The send level will be fixed at nominal level, and the send point will be fixed at POST FADER. For details, see "Basic settings for MIX buses and MATRIX buses" on page 189. • Press the SEND knob or PAN knob on screen to open the SEND 8ch window. SELECTED CHANNEL section  GAIN/PATCH field This field enables you to make HA (head amp) analog or digital gain settings. You can also view the operational status of the head amp. 1 GAIN knob Sets the analog gain/digital gain of the head amp. Press the knob to open the GAIN/PATCH 1ch 2 window. 1 3 4 2 GC indicator Indicates the level of the signal output to the audio network if the Gain Compensation function is turned on. 5 67 8 3 OVER indicator Warns you when the signal is clipping. 4 Ø (Phase) indicator Indicates the status of the phase setting. 5 +48V indicator Indicates the phantom power (+48V) on or off status for the head amp. 6 HPF ON indicator Indicates the HPF on/off status of the external head amp. 7 AG-DG LINK indicator Indicates a link between the analog gain and digital gain of the head amp. 8 Digital/Analog gain value If analog gain is assigned to the GAIN knob, the digital gain value is shown here. If digital gain is assigned to the GAIN knob, the analog gain value is shown here. NOTE • For an input channel that is patched to an input that has no head amp, 1, 2, 5, 6, and 7 will not be shown. For an output channel, 1-7 will not be shown. • If GAIN KNOB FUNCTION is set to DIGITAL GAIN in the USER SETUP PREFERENCE screen, the digital gain knob will appear for 1, and 2, 5, 6, and 7 will not be shown. For details, refer to "Making HA (Head Amp) settings" on page 26. 7 Reference Manual