Yamaha QL5 Reference Manual - Page 65

CH LINK MODE window You can view the channels that are linked and specify the parameters that will be linked. 1 2 3 4 1 Channel display field When you create a link group, the corresponding channels will be highlighted. If there are two or more link groups, each group is shown in a different color. Press this field to open the CH LINK SET window. You can also link channels in this window. NOTE • Left and right of the ST IN channel are always linked. • In the case of the QL1, faders that do not exist on the model will not be shown. 2 Link indicator If a channel belonging to a link group is selected, the associated link group is shown. The LINK PARAMETER field and SEND PARAMETER field show the link settings. While you hold down the [SEL] key of a channel that does not belong to any link group, the link indicator shows the link group that will be created next. The LINK PARAMETER field and SEND PARAMETER field show the settings of the link group that had been previously displayed. Channel Job 3 LINK PARAMETER field Use the buttons in this field to select the parameters that you want to link. You can do this independently for each link group. The table below lists the parameters you can select in the LINK PARAMETER field. HA HPF DIGITAL GAIN EQ DYNAMICS 1, 2 INSERT DIRECT OUT MIX SEND MIX ON MATRIX SEND MATRIX ON FADER DCA CH ON MUTE TO STEREO DELAY Head amp settings HPF settings Digital gain settings EQ settings Dynamics 1 and 2 settings Insert settings Direct Out settings Send levels of signals sent to MIX buses On/off status of signals sent to MIX buses Send levels of signals sent to MATRIX buses On/off status of signals sent to MATRIX buses Fader operations DCA group assignment Channel on/off Mute group assignment On/off status of signals sent to STEREO/MONO buses Channel delay settings NOTE • If you link Dynamics 1 or 2 for two or more input channels, the parameter values will be linked, but the key-in sources are not linked and can instead be set for each channel. The behavior of key-in signals is linked in units of 8ch*. For details about dynamics, see "EQ and Dynamics" on page 49. * Units of 8ch means Ch1-8, Ch9-16, Ch17-24, Ch25-32, Ch33-40, Ch41-48, Ch49-56, Ch57-64, ST IN 1L-ST IN 4R, and ST IN 5L-ST IN 8R. • If you turn on the EQ button or DYNAMICS 1/2 buttons, library recall operations will also be linked. • The HA analog gain setting and the fader operation will be linked and will maintain the same relative level difference between the channels. • In the insert settings, the parameters for Insert 1 and Insert 2 are selected together. 65 Reference Manual