Yamaha QL5 Reference Manual - Page 92
Operating the Cue function
![]() |
View all Yamaha QL5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
4 Other CUE group These cue signals are operated via buttons displayed on the touch screen. This group is enabled if you turn on the CUE button in the EFFECT window or the PREMIUM window, or if you turn on the KEY IN CUE button in the DYNAMICS 1 window. This group will automatically be disabled when you exit the corresponding window. On-screen CUE button NOTE You cannot turn on cue monitoring between different groups simultaneously. Normally, the group to which the most recently-pressed [CUE] key (or on-screen CUE/KEY IN CUE button) belongs will take priority, and the [CUE] keys for the previously-selected group will be defeated. However, if you have switched the cue signal group in a specific order when the CUE MODE setting is MIX CUE, the state of the [CUE] keys for the previously-selected group will be restored when the current cue signal is defeated. The right illustration shows the priority order of the [CUE] keys. After you have switched groups from lower to Other CUE group upper levels, if you then defeat cue for the upper group, the previous [CUE] INPUT CUE group key status of the group immediately below will be restored. For example, if you switch groups in the order of OUTPUT CUE group DCA CUE group INPUT CUE group Other CUE group, you can then DCA CUE group OUTPUT CUE group successively defeat the [CUE] keys (CUE/KEY IN CUE buttons) to successively restore the [CUE] key status of the previously-selected group. Monitor and Cue functions Operating the Cue function This section explains how to use the [CUE] key for a channel or DCA group to monitor cue signals. NOTE Be aware that if you turn CUE INTERRUPTION off in the MONITOR popup window, the cue signal will not be sent to the connected monitor speakers. However, the front panel PHONES jack will always output the cue signal regardless of the Monitor on/off setting. See "Using the Monitor function" on page 88 for details about the Monitor function. STEP 1. In the Function Access Area, press the MONITOR button. 2. Press the CUE display button or the INPUT/DCA/OUTPUT CUE field in the MONITOR screen. 3. Use the CUE MODE button to select either the mode in which channels are mixed for auditioning, or the mode in which only the last-selected channel is auditioned. 4. Use the buttons and knobs of the INPUT CUE/DCA CUE/OUTPUT CUE field to specify the output position and output level for each CUE group. 5. Press one of the CUE OUT PATCH buttons (L/R) in the meter field to specify a port as the output destination for cue signals L and R (multiple selections are allowed). 6. To enable cue out for the port you specified in step 5, press the CUE OUTPUT button to turn it on. 7. Press the [CUE] key of the channel or DCA group to be monitored to turn it on. 8. Adjust the cue signal level by using the [TOUCH AND TURN] knob to operate the CUE LEVEL knobs in the CUE field. 9. To defeat cue, press the currently-on [CUE] key once again. To clear all cue selections, press the CLEAR CUE button in the Meter field. MONITOR screen 92 Reference Manual
![](/manual_guide/products/yamaha-ql5-reference-manual-f6aaad0/92.png)