Compaq ProLiant 1000 ProLiant Server Troubleshooting Guide - Page 184

POST Error Messages Table C-2: Non-Numeric Error Messages or Beeps Only continued Error Code Audible Beeps Probable Source of Problem Action ECC Multiple Bit Error None Detected in DIMM X A memory module failure generated a multiple bit error that could not be corrected. Run Diagnostics and replace failed memory module as indicated. ECC Multiple Bit Error Detected in DIMM/SIMM pair: DIMM X None A memory module failure generated a multiple-bit error that could not be corrected. Run Diagnostics and replace failed memory module as indicated. FATAL ROM ERROR: The System ROM is not properly programmed. Fixed Disk Parameter Table or BIOS Error System Halted 1 long, 1 short None The System ROM is not properly programmed. Replace the physical ROM part. An error occurred while attempting to communicate with the CD-ROM/diskette drive assembly. This assembly may not be seated properly. 1. Reseat the CD-ROM/diskette drive assembly. 2. Check the media currently in the drive. Initialization failure. Re-seat the processor and Processor Power Module before attempting replacement None Processor was not fully seated. A processor internal failure occurred. 1. Reseat the processor. 2. Replace the processor if the failure recurs. Invalid electronic serial number None Serial number in BIOS is incorrect. Run the server setup utility to program serial number. Loss of Nonvolatile None Configuration Memory Nonvolatile memory has been corrupted or cleared. No action needed. System will automatically load default nonvolatile configuration. Network server mode active and no keyboard attached None This is not an error but simply displays when keyboard is not connected. No action required. continued C-4 HP Servers Troubleshooting Guide