Compaq ProLiant 1000 ProLiant Server Troubleshooting Guide - Page 290

Index invalid processor PPM installed C-20 invalid voltage regulator module installed C-20 IP, accessing 5-10 IP/IPX, using network features 5-6 IRC (Integrated Remote Console) A-8 IRC configuration invalid C-11 IRQ settings, determining 1-13 K keyboard POST error messages C-4, C-5, C-25, C-26 problems 2-38, 2-39 test error codes B-2, B-5 keyboard controller error C-25, C-26 keyboard controller self-test failed B-2 keyboard error C-25 keyboard error or test fixture installed C-25 keyboard LED test, 8042 self-test failed B-5 keyboard long test failed B-5 keyboard or system unit error C-26 keyboard short test, 8042 self-test failed B-5 keyboard typematic test failed B-5 L label placement, tape cartridge 6-6 LEDs 2-8 less than 75% batteries at sufficient voltage D-10, D-11 light emitting diodes See LEDs cache has been disabled D-5 line voltage 2-5 Linux event list messages 4-17 kernel panic 4-17 recovery software 3-7 technical support, information required 1-24 locating information HP resources A-1 in this guide 1-18 locked SCSI bus detected C-44, C-48 log reinitialized C-13 log reinitialized because length check out of bounds C-13 logical drive X failed due to cache error D-11 logical drive X status = failed D-11 logical drive X status = interim recovery D-11 logical drive X status = loose cable detected D-12 logical drive X status = overheated D-12 logical drive X status = overheating D-12 logical drive X status = recovering D-12 logical drive X status = wrong drive replaced D-12 loose cable detected - logical drives may be marked FAILED until corrected D-12, D-13 loose connections 1-6, 1-9, 1-11, 1-14, 2-10 loss of nonvolatile configuration memory C-4 low system battery C-42 LVD (low voltage differential) D-24 HP Servers Troubleshooting Guide Index-15