Compaq ProLiant 1000 ProLiant Server Troubleshooting Guide - Page 279

Index UPS, warning 2-8 batteries less than 75% at sufficient charge D-10 battery pack X below reference voltage D-11 battery pack X below reference voltage, array accelerator D-5 battery pack X not fully charged, array accelerator D-5 baud rate, setting 2-46 beeps, not heard during POST 2-37 BIOS Serial Console 4-18 BIOS Setup Utility A-6 blank screen 2-35, 2-36 blanking panels 2-27 board in use by expand operation D-5 board not attached D-5 boot, defined xii booting problems 1-6, 1-7, 1-8, 1-9, 1-10, 1-11, 1-12, 1-13, 1-14, 2-5, 2-6, 2-7, 2-8, 2-9, 2-10, 2-11, 2-12, 2-16 bootstrap processor is not the lowest stepping processor in the system C-32 brownout, defined 6-8 bus, SCSI See SCSI bus C cables connections, network problems 2-42 damage, preventing 6-12 drives, ADU error messages D-7, D-11, D-12, D-13, D-15, D-19, D-20, D-21 rack considerations 2-38 SCSI bus, ADU error messages D-17, D-19, D-20 cabling order 2-10 cache accelerator RAM, POST error messages C-22, C-23 ADU error messages D-2, D-3, D-4, D-11, D-14, D-25 drive write D-24 cache accelerator Slot X initialization failed C-23 cache accelerators not installed C-22 cache controller error C-15 cache has been disabled because ADG enabler dongle is broken or missing D-5 cache memory error C-14 cache test failed B-2 cache was automatically configured, accelerator status D-2 Caldera and SCO operating systems drivers, accessing latest 3-13 EFS 3-13 emergency boot diskette 3-7 event list messages 4-17 kernel panic 4-17 recovery software 3-7 technical support, information required 1-26 CarePaq A-3 CD-ROM drive cannot read data 2-23 connection problems 2-24 drivers 2-24 invalid format 2-23 media problems 2-23 POST error messages C-4 problems 2-23 SCSI ID setting 2-26 system boot 2-23 test error codes B-14 undetected 2-24 USB problems 2-23 CD-ROM ID failed B-14 CD-ROM read failed B-14 invalid memory configuration B-4 Index-4 HP Servers Troubleshooting Guide