Compaq ProLiant 1000 ProLiant Server Troubleshooting Guide - Page 84

Hardware Problems Table 2-18: Network Controller Problems continued Problem Possible Cause Possible Solution Network controller stops working when an expansion board is added. The cable is not securely connected. Be sure that the cable is secured to the network connector and that the other end of the cable is securely connected to the correct device. Network controller interrupt overlaps the interrupt of an expansion board. Modify one of the overlapping interrupt values. To do this, either: Make the change in your server setup utility. -Or- Run the setup utility provided by the operating system. The files containing the network drivers are corrupt. Reinstall the network drivers. Network drivers are not loaded, or driver parameters do not match current configuration. 1. Be sure that the drivers were not deleted when the drivers for the new expansion board were installed. 2. Refer to your operating system documentation to verify that the correct drivers are installed. 3. Refer to your operating system documentation to be sure that the driver parameters match the configuration of the network controller. You are having problems with the network interconnect blades (if available for your server). Network interconnect blades are not properly seated. Be sure that the network interconnect blades are properly seated and connected. 2-42 HP Servers Troubleshooting Guide