Sharp MX-M4070 User Manual - Page 129

BEFORE USING THE MACHINE►HOW TO PLACE THE ORIGINAL DOCUMENT GLASS This section describes the steps for setting the original on the document glass. • Close the automatic document feeder slowly. Abruptly closing the automatic document feeder may damage it. • Take care that your fingers are not pinched when closing the automatic document feeder. Allowed original sizes Maximum original size Standard size 11" (longitudinal) x 17" (transversal) 297 mm (longitudinal) x 420 mm (transversal) or A3 Non-standard size 11-5/8" (longitudinal) x 17" (transversal) 297 mm (longitudinal) x 432 mm (transversal) When the original is a non-standard size, see the appropriate explanation below for the mode you are using. ► COPIER: "SELECTING THE ORIENTATION AND SIZE OF THE ORIGINAL (page 2-27)" ► FAX: "SPECIFYING THE ORIGINAL SCAN SIZE USING NUMERIC VALUES (page 4-43)" ► IMAGE SEND: "SPECIFYING THE ORIGINAL SCAN SIZE USING NUMERIC VALUES (page 5-51)" 1 Open the automatic document feeder. 2 Load the paper with the print side facing down. Original size detector Place the original face down and align the top left corner of the original with back left (at the tip of the mark ) of the document glass. Mark Document glass scale Y X Do not place any objects under the original size detector. Closing the automatic document feeder with an object underneath may damage the original size detector or disable correct detection of the original size. When placing a non-standard size original on the document glass, the size can be detected easily if a blank sheet of 8-1/2" x 11" (A4), 5-1/2" x 8-1/2" (B5), or other standard size paper is placed on top of the original. 1-126