Sharp MX-M4070 User Manual - Page 835

SYSTEM SETTINGS►SYSTEM SETTINGS Timeout Enter a timeout. The default setting is 20 seconds. This value is used for connection to the SMTP server and for data transmission according to the e-mail system specifications. Sender Name Enter a maximum of 20 full-width/half-width characters for the sender name. Sender Address Enter a maximum of 64 half-width characters for the sender address. Enable SSL If the SSL is enabled, the SMTP-over-TLS encryption communication can be used by STARTTLS command. This requires the server to support the STARTTLS command. To allow SSL communication, set the "Port Number" to the same port number as the normal SMTP. SMTP Authentication Carries out the SMTP server authentication. If you use the Kerberos authentication, set the KDC server, port number, and realm on the Kerberos authentication settings page. User Name Enter the user name. Password Enter the password. To change the password, set [Change Password] to . POP before SMTP If is set, you are authenticated to the POP server before using the SMTP communication. • POP3 Server: Enter the IP address or the host name of the secondary SMTP server. • Port Number: Enter the POP3 port number for POP before SMTP communication. The default setting is port 110. • POP Authentication: If is set, the authentication protocol (including APOP) is used for authentication to the POP3 server. • User Name: Enter the user name for POP before SMTP communication. • Password: Enter the password required for POP before SMTP communication. To change the password, set [Change Password] to . • Enable SSL: If set to , the POP over SSL communication or the POP over TLS communication by STLS command is enabled. This requires the server to support the POP over SSL communication or the STLS command. To allow SSL communication, set the "Port Number" to the POP over SSL communication port number. To allow POP over TLS communication, set the "Port Number" to the same port number as for the normal POP3 communication. Connection Test Tap the [Execute] button to test the connection to the SMTP server. Kerberos Kerberos Authentication Settings KDC Server Enter the IP address or host name of the Kerberos authentication server. Port Number Enter the port number of the Kerberos authentication server. The default setting is port 88. Realm Enter the Kerberos realm. SNTP SNTP Settings SNTP Set this option to use the SNTP protocol. SNTP Server Enter the IP address or host name of the SNTP server. 7-81