Sharp MX-M4070 User Manual - Page 534

FACSIMILE►OTHERS FUNCTION 3 Tap the [Others] key, and tap the [Transaction Report] key. 4 Others Transaction Report Do not Print Print at Error Always Print Print Original Image Tap the key of the print settings. After the settings are completed, tap sequence. and [Back] keys in Preview CA Back reception memory 100% Speaker Start To cancel the transaction report setting: Tap the [Do not Print] key. • The print conditions for a transaction report are as follows: • "Always Print": A transaction report is printed no matter whether the transmission succeeds or fails. • "Print at Error": A transaction report is printed when transmission fails. • "Do not Print": Do not print a transaction report. • Set the [Print Original Image] checkbox to report. to include the first page of the transmitted original in the transaction • Even if the [Print Original Image] checkbox is , the original cannot be printed when speaker dialing, manual transmission, direct transmission, polling reception, or F-code transmission is used. 5 Tap the [Start] key to start scanning of the original. • If you inserted the original pages in the document feeder tray, all pages are scanned. • A beep will sound to indicate that scanning and transmission have ended. • When you place the original on the document glass, scan each page one at a time. • When scanning finishes, place the next original and tap the [Start] key. Repeat until all pages have been scanned and then tap the [Read-End] key. A beep will sound to indicate that transmission has ended. You can tap the [Preview] key to check a preview of the image before sending a fax. For more information, see "CHECKING THE IMAGE TO BE TRANSMITTED (page 4-27)". However, settings for this function cannot be changed in the preview screen. Original image in transaction report When [Print Original Image] is enabled, the first page of the transmitted original is printed on the same sheet as the transaction report. The original image is reduced to allow it to fit on the sheet. If the vertical scanning length (X direction) of the original is longer than 432 mm (17-1/64"), the part that exceeds 432 mm (17-1/64") may be cut off. 4-101