Sharp MX-M4070 User Manual - Page 285

COPIER►OTHER FUNCTIONS ERASING PERIPHERAL SHADOWS FOR COPYING (ERASE) The erase function is used to erase shadows around the edges of copies that occur when copying thick originals or books. When a thick book is copied Not using the Erase Using the Erase Shadows appear here Erase modes Outer Frame Erase Center Erase Shadows appear on the copy Shadows do not appear on the copy Edge + Center Erase Side Erase • If a ratio setting is used in combination with an erase setting, the erase width will change according to the selected ratio. If the erase width setting is 1" (20 mm) and the image is reduced to 50%, the erase width will be 1/2" (10 mm). • This function erases the parts of the image where shadows tend to form, but does not detect shadows and erase only the shadows. • When Erase is selected, the orientation of the original is automatically set to portrait. To change the default erase width setting: In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Condition Settings] → [Erase Width Adjustment]. Specify a value from 0" (0 mm) to 1" (25 mm) in increments of 1/8" (3 mm) for both edge erase and center erase. The changed setting is also applied to the Setting mode selection of [System Settings] → [Image Send Settings] → [Common Settings] → [Condition Settings] → [Erase Width Adjustment]. 1 Place the original. Place the original in the document feeder tray of the automatic document feeder, or on the document glass. ► AUTOMATIC DOCUMENT FEEDER (page 1-124) ► DOCUMENT GLASS (page 1-126) 2 Tap the [Others] key, and tap the [Erase] key. 2-77